45
Getting started (Stereo receiver: SX-P01, SX-P01DAB)
11
11
Muting
The volume is muted temporarily when pressing the
MUTE
button on the remote control. Press again to restore the
volume.
DIRECT function
Press the
DIRECT
button on the remote control or on the
stereo receiver to listen to the sound source in the original
sound quality. The
DIRECT
indicator lights in the front panel
display of the stereo receiver when the DIRECT function is on.
Press the
DIRECT
button again to cancel the DIRECT
function.
Note
•
If the DIRECT function is turned off when the volume is set
to 61 or higher, the volume is automatically set to 60.
Bass control
Press the
BASS +
button on the remote control to emphasize
the bass, and the
BASS–
button to de-emphasize it.
Note
•
This function is not available when the DIRECT function is
on.
Treble control
Press the
button on the remote control to
emphasize the treble, and the
TREBLE–
button to de-
emphasize it.
Note
•
This function is not available when the DIRECT function is
on.
Input selection
The input source for the stereo receiver can be selected by
pressing each input selection button (
CD
/
USB
,
TUNER
,
NETWORK
, and
DIG IN 1/2
) on the remote control, or turning
the
SOURCE
knob on the stereo receiver.
Note
•
If pressing the
INPUT
button on the remote control
repeatedly or turning the
SOURCE
knob on the stereo
receiver to the right, the input source is switched in the
following order.
If turning the
SOURCE
knob to the left, the order is reversed.
•
The backup function will memorize the input mode and
restore it in case of a power failure or that the AC power
cord is disconnected.
Headphones
Plug headphones (commercially available) into the PHONES
socket on the stereo receiver.
•
Do not turn the volume on to full at switch on and listen to
music at moderate levels. Excessive sound pressure from
earphones and headphones can cause hearing loss.
•
Before plugging in or unplugging the headphone, reduce
the volume.
•
Be sure your headphone has a 3.5 mm diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
•
Plugging in the headphone disconnects the speakers
automatically.
Auto power down setup
The unit turns off automatically if no operations are performed
for specified period of time.
•
Default setting: 6H
1
Press the CONTROL RCV button on the remote control.
2
Press the SETUP button.
3
Press
/
to specify the amount of time.
You can select 2, 4 or 6 hours, or off (if no automatic
shutoff is desired).
4
Press the ENTER button.
Note
•
Press the
RETURN
button to exit the setting mode without
setting the auto power down function.
CAUTION
•
If setting the auto power down for the stereo receiver, both
of the stereo receiver and CD player are automatically
turned off after the specified period of time has elapsed. If
setting the auto power down for the CD player, only the CD
player is automatically turned off after the specified period
of time has elapsed.
TUNER
DIGITAL IN 1
CD/USB
NETWORK
DIGITAL IN 2
