Connecting the units
Connecting the power cord
Connection method
1. Clamp the lead.
2. Clamp firmly with
needle-nosed pliers.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner’s Manual or dealer.
Yellow/black
If you use equipment with Mute function, wire this lead to the
Audio Mute lead on that piece of equipment. If not, keep the
Audio Mute lead free of any connections.
Light green
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch.
Blue/white
Connect to system control terminal of the power
amp or auto-antenna relay control terminal (max.
300 mA 12 V DC).
Ground side
Power supply side
Parking brake
switch
When you connect the separately sold
multi-channel processor (e.g., DEQ-P8000) to
this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
Yellow
Connect to the constant 12 V supply terminal.
Fuse resistor
Red
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Fuse resistor
Orange/white
Connect to lighting switch terminal.
Left
Right
Front speaker
Front speaker
Rear speaker or
Subwoofer (4 Ω)
White
Gray
Gray/black
White/black
Green
Violet
Green/black
Violet/black
With a 2 speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
Note:
· Change the initial setting of this unit (refer to the
Operation Manual). The subwoofer output of this unit is
monaural.
Violet
Violet/black
Not used.
Green
Green/black
When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not
connect anything to Green and Green/black leads.
Subwoofer (4 Ω)
× 2
Rear speaker or
Subwoofer (4 Ω)
Fuse (10 A)
This product
Antenna input
Connecting the units
Connecting the units
When connecting to separately sold power amp
Note:
· Change the initial setting of this unit
(refer to the Operation Manual).
The subwoofer output of this unit is monaural.
Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control
terminal.
(max. 300 mA 12 V DC).
When you connect the separately sold
multi-channel processor (e.g., DEQ-P8000) to
this unit, do not connect anything to the
speaker leads and system remote control
(blue/white).
This product
Connect with RCA cables (sold
separately)
Rear speaker
or Subwoofer
Perform these connections when
using the optional amplifier.
System remote control
Front speaker
Front speaker
Left
Right
Front output
When you connect the multi-channel processor
to this unit, refer to multi-channel processor’s
installation manual for the connection method.
Rear speaker
or Subwoofer
Power amp
(sold separately)
Power amp
(sold separately)
Rear output or
subwoofer output
Connecting the units
Connecting the system
iPod with Dock
connector
Dock connector
Interface cable
(e.g., CD-I200) (sold separately)
Gray
This product
1.5 m (4 ft.11 in.)
20 cm
(7-7/8 in.)
USB cable
Connect to sparately sold
USB device.
Wired remote input
Hard-wired remote control
adaptor can be connected
(sold separately).
Multi-CD player
(sold separately)
2 m (6 ft.7 in.)
