BASIC
OPERATIONS
BEFORE
OPERATING
VARIOUS
OPERATIONS
9
<PRB1268>
En
STANDBY / ON
POWER
UNLOAD
OPEN/
CLOSE
HOW TO LOAD THE DISCS
(Be sure to read this before operation)
÷
To load or remove a disc in or from the slot which is seen through
the hood, press
OPEN/CLOSE
. The hood is opened,
“HOLD”
is
displayed and the disc can be loaded in or ejected from the slot
seen through the hood. Even while
“HOLD”
is being displayed,
the rack can be rotated by pressing
DISC (–/+)
.
÷
Be sure to remove all discs from the rack, set the
POWER
STANDBY/ON
switch to off, and unplug the power cord before
moving the unit.
Loading discs into the rack
÷
You can load up to
100 discs
in the rack.
The numbers marked on the rack are used as the disc numbers.
These are marked in the clockwise order from
1
to
100
.
÷
If a disc is inserted with its label side facing to the right, it cannot
be played back. Be sure to load all discs with their label sides facing
to the left.
WARNING:
Do not put your hand or any other object inside
the rack, otherwise injury or part damage may
result.
÷
The following procedure describes how to load discs from
disc No. 1.
Press POWER STANDBY/
ON switch.
D
Press UNLOAD.
«
The hood will open.
1
2
Notes!!
÷÷÷÷÷
Do not attempt to open the hood with your hand.
÷
Be careful not to pinch your fingers when opening and closing the
hood.
÷÷÷÷÷
Do not put anything other than CDs inside the rack.
÷÷÷÷÷
Do not use adapters for 8-cm (3-in.) CDs.
÷
Load only one disc into each disc slot.
÷
Inserting an 8-cm (3-in.) CDs in between two 12-cm (5-in.) CDs,
will make it difficult to remove the 8-cm (3-in.) CD.
We recommend inserting 12-cm (5-in.) CDs starting from Disc No.
1 (i.e., 1, 2, 3...) and 8-cm (3-in.) CDs starting from Disc No. 100
(i.e., 100, 99, 98...).
÷
The unit will not operate if the hood is opened during playback. Be
sure to close the hood before attempting any operations.
D
To remove the discs...
Press UNLOAD.
Select the disc No. to be removed by pressing DISC(–/+).
÷
The rack rotates until the selected disc comes in the front of
the unit.
Remove from the rack.
Press OPEN/CLOSE.
÷
The hood will close.
Press DISC(+) to rotate
the rack.
÷
The rack rotates in the di-
rection of 1,2,3.... Press-
ing
DISC(–)
rotates the
rack in the opposite direc-
tion.
Load other discs into the rack by repeating
steps 3 and 4 for each of them.
Press OPEN/CLOSE.
÷
The hood will close.
4
5
6
Tip:
Difference between
OPEN/CLOSE
and
UNLOAD
OPEN/CLOSE:
The hood is simply opened or closed.
UNLOAD:
The slot corresponding to the disc No. being displayed
rotates to the center position then the hood is opened.
1
2
3
4
When
UNLOAD
is pressed,
the hood opens to the disc
corresponding to the disc No.
displayed on the front of the
unit. Therefore, if you want to
load discs from No. 50, use
DISC (–/+)
on the unit to dis-
play “50”, or enter “50” using
the remote control unit, before
pressing
UNLOAD
.
Load the disc into the
rack with the label side
(printed surface) facing
to the left.
Side to be played faces right
(label side faces left)
D
3
÷
Ensure that the disc No.
shown on the display is “1”.
÷
If the displayed disc No. is
not “1”, press
DISC(–/+)
to display “1”.
BEFORE
OPERATING
DISC
MIN
SEC
TRACK
ALL
DISC
