123
Menu Mode
7) Auto Set Up Mode Setting
This function automatically adjusts the signal when the power is turned ON, when the input is changed, and when
the type of input signal is changed.
Factory setting: INACTIVE
1
Select ‘OPTION’.
2
Place the cursor on ‘AUTO SET UP MODE’ then press
the [SET] button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
Notes
• Items 1 and 3 are adjusted automatically.
‘SCREEN’ Adjustment inside the menu: 1. ‘POSITION’
2. ‘CLOCK’
3. ‘PHASE’
• The adjustment items are the same as when the ‘AUTO SET UP’ button is pressed on the remote control; however,
precision may be a little inferior. This difference in precision is due to short processing time in the menu settings
AUTO SET UP MODE.
• It may not be possible to precisely adjust an input signal such as when the signal has low brightness. Set the
AUTO SET UP MODE to INACTIVE, and make adjustments as explained in the following section, ‘SCREEN, CLOCK,
PHASE’.
• When the AUTO SET UP MODE is set to ACTIVE and ‘SCREEN’ is manually adjusted, ‘AUTO SET UP MODE:
ACTIVE’ is displayed.
This is to warn you that although adjustment is manual, when the input changes or when the type of signal changes
on the outside, the AUTO SET UP MODE functions and the adjusted values will be written over.
M E N U
I N P U T 1
CHANGE
SET
EXIT
MENU
S C R E E N
S E T U P
O P T I O N
L A N G U A G E
E N E R G Y S AV E
T I M E R S E T T I N G
S C R E E N M G T.
S P L I T F R E E Z E
A U T O S E T U P M O D E
A U T O F U N C T I O N
P I P D E T E C T
P I C T U R E
: S TA N D A R D
: I N A C T I V E
: O F F
: A C T I V E
: E N G L I S H
: O F F
Screen
2
3
INACTIVE
ACTIVE
2
