132
Menu Mode
2) Power Management and Auto Power OFF Setting
When no video signal (synchronizing signal) is detected, this function automatically sets the energy saving state in
order to save power.
• To disable the energy saving function, set to [OFF/DISABLE].
• When there is video signal input:
To set the power standby state when the input signal is not detected within 8 minutes, set ‘AUTO POWER OFF’
to [ENABLE].
• When there is PC signal input:
To switch between the normal-operation state and the energy saving state depending on whether or not there is
an input signal, set ‘POWER MANAGEMENT’ to [ON].
Settable condition : Power management: INPUT1, INPUT2 (PC signal), INPUT5
Auto power OFF: Conditions other than those above
Factory setting
: OFF/DISABLE
Notes
• To return from the power standby state to the normal operation state, press the power button on the remote
control or the main control panel.
• To return from the energy saving state by power management to the normal operation state, operate the personal
computer or press the [INPUT] button on the remote control or main-control panel.
However, during SYNC ON G or composite SYNC input operation does not return by simply operating the personal
computer. After operating the personal computer, press the [INPUT] button.
• The power consumption during power standby.
PDP-425CMX: 1.2 W
PDP-42MXE10: 1.5 W
M E N U
I N P U T 1
CHANGE
SET
EXIT
MENU
S C R E E N
S E T U P
O P T I O N
P O W E R M G T.
: O F F
S I G N A L F O R M AT
P I C T U R E
3
OFF/DISABLE
ON/ENABLE
2
1
Select ‘SETUP‘.
2
Place the cursor over ‘POWER MANAGEMENT (AUTO
POWER OFF)’ and change the setting with the [SET]
button.
Each time the [SET] button is pressed, the setting is
changed as shown below.
