154
Integrator Mode
5.4 Integrator Mode
5.4.1 About the Integrator Mode
1) Entering the Integrator Mode
• It is possible to set the integrator mode by the following procedure.
1
Press the [DISPLAY] button to display ‘DISPLAY CALL 1’.
2
When ‘DISPLAY CALL 1’ is displayed, press the [DISPLAY] button again (for 3 seconds or more) to display
‘DISPLAY CALL 2’.
3
It is possible to enter the integrator mode by pressing the [MENU] button when ‘DISPLAY CALL 2’ is displayed.
At this time, press the [MENU] button briefly (the integrator mode cannot be entered if the [MENU] button is held
down for a longer period of time).
2) After entering the integrator mode...
• The adjustment values for COLOR TEMP, DNR, MPEG NR, CTI and PURECINEMA for the PICTURE, SCREEN and
SETUP are all set to their initial values.
The other SETUP and OPTION settings retain their set values.
3) Making adjustment in the integrator mode
• The adjusted values (see section 5.4.3, “Adjustment and Setting in the Integrator Mode 1) to 3)” (pg. 156 to 158))
for PICTURE and SCREEN can be stored in memory for 8 types of input signals (input frequency) for each function.
When a new ninth type of input signal is adjusted, the adjustment data for the oldest input signal is deleted.
• For details, refer to section 5.4.4, “PICTURE, White Balance and SCREEN Position Adjustment Values Memory
Area Tables” (pg. 187).
4) Exiting the integrator mode
• Press the [MENU] button on the remote control or main-control panel to designate to the normal-operation mode.
5) Precautions
(1) In the following cases the integrator mode is automatically cancelled and operation returns to the normal-operation
mode:
• When the input is switched
• When there is no operation for 3 minutes
(2) Adjustment and settings should be performed on the actual video signal to be used or on an adjustment signal
having the same frequency.
(3) The method for entering the integrator mode for PDP-503CMX (pressing the [MENU] button in standby and then
pressing the [POWER] button) is not supported.
(4) Only English is supported in the integrator mode.
(5) During Point Zoom operation or multi-screen display, ‘DISPLAY CALL 2’ is unavailable even if the [DISPLAY]
button is pressed. After disengaging Point Zoom or multi-screen display, follow the instructions under 1) Entering
the Integrator Mode (pg. 113).
