73
Wall Mount Unit: PDK-WM01
6
Hang the hook of the PDP side metal fitting on the
wall side metal fitting
1
Hang the hook on the ceiling surface part of the
PDP side metal fitting on the wall side metal
fitting.
2
Raise the lock bar to attach the Plasma Display.
Make sure that the lock bar is fully lowered.
Hook of the PDP side
metal fitting
Lift the lock bar to its
unlocked position.
Hang the hook.
1
2
Always have at least 2 people do this task.
Check that the hook has been hung before
lifting the Plasma Display.
Caution
7
Fine adjustment of the left-right tilt of the Plasma
Display.
If the Plasma Display is slightly tilted to the left or right
after it is installed on the wall, adjust this tilt by attaching
the adjustment metal fitting (at lone location on the
right and on the left).
Insert the tilt adjustment metal fitting in the notch on
the top surface of the PDP side metal fitting that is
tilted downward. Attach it by rotating the screw.
1
Rotate the screw until the gap between the wall
side metal fitting and the tilt adjustment metal
fitting disappears. When the gap between the
wall side metal fitting and the tilt adjustment
metal fitting has disappeared, the screw becomes
difficult to rotate and begins to lift up the Plasma
Display.
2
Rotate the screw to adjust the tilt.
Gap
Screw head
Tilt adjustment
metal fitting
Tilt adjustment
metal fitting
5
Install the wall side metal fitting to the wall
Fix it firmly in place symmetrically to the left and right
(4 or more locations).
Wall strength and material determines the type of
screws and bolts (sold separately) needed for this
installation.
Note
Chack the strength of the wall, columns, etc. before
beginning the installation.
Notes
If speakers are attached, do not hold the
speakers to perform this attachment.
Be careful that the wiring etc. is not caught in the
metal fitting or on the Plasma Display. When a
speaker is attached, the wiring is easily caught
between the wall and the speaker.
Note
The range that the tilt can be adjusted by the screw
is about 5 mm (3/16 inch). The screw rotates about
3 times. Be careful not to over-rotate the screw.
If the screw is turned too much, the metal fitting
may be damaged.
