Using the unit
07
15
En
English
Connecting the unit to a Pioneer plasma television (see Chapter 8)
Operations, indicators, conditions, and precautions when connecting the unit to a Pioneer plasma television are as
follows:
* See the section
Features
(page 7) regarding the model numbers of supported Pioneer plasma televisions.
Connecting the unit to other televisions (see Chapter 9)
Operations, indicators, conditions, and precautions when using the unit as an AV selector are as follows:
Independent 2 mode
Operations:
• HDMI Control function is not used.
• The unit does not operate in linkage to other components,
but as an independent component.
• The
INPUT
button on PDA-V100HD and its remote control
unit can be used to switch the unit’s corresponding
INPUT 1 to INPUT 6.
Settings required on this unit:
HDMI CONTROL
switch:
OFF
Operations
• The plasma television’s remote control can be used to control the unit’s input selector.
• The unit’s power switch is linked to that of the plasma television; when the plasma television’s power
switch is set to off, this unit’s power is also automatically turned off.
Indicators
The HDMI CONTROL indicator lights green.
Conditions
• The
HDMI CONTROL
switch must be set to
ON
.
• The plasma television’s “HDMI Control Setting” menu must be set to allow control of this unit.
Note: For setting details, consult the Operating Instructions for your plasma television.
Precautions
• The
INPUT
button and the remote control’s
INPUT
(
1
to
6
) buttons cannot be used to change the
unit’s input selection.
• The input selection for the component connected to INPUT 6 connector cannot be changed.
• If the
HDMI CONTROL
switch is set from
ON
to
OFF
, be sure also to cancel the plasma television’s
“HDMI Control Setting”.
Operations
• The
INPUT
button and remote control’s
INPUT
(
1
to
6
) buttons can be used to change the unit’s input
selection.
Indicators
The HDMI CONTROL indicators do not light.
Conditions
• The
HDMI CONTROL
switch must be set to
OFF
.
Precautions
• The plasma television’s remote control cannot be used to control the unit’s input selector.
Operation modes
Operations/Operation restrictions
HDMI Control setting
