5
En
English
Installation screws
2
(M8 x 30 mm: black)
Attaching the Plasma Display
The weight of a 50 inch plasma display is about 40 kg
(88 lbs), that of a 43 inch model is about 30 kg (66 lbs),
they have no depth, and are unstable. Therefore, at
least two people must assemble and install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Make sure that you install the support columns reliably
according to the settings of the type of speakers you have
purchased with reference to the procedure in Assembling
the Stand.
Attachment Method
1
Attaching the plasma display to the stand.
Fit the stand’s support columns to the bottom of the
plasma display as indicated by the arrows, then slowly
insert them vertically. Be extremely careful not to insert the
support columns of the stand into any part of the plasma
display other than the stand insertion slots. Note that doing
so might damage the plasma display panel or its ports or
result in the warping of the stand.
Line up the column
supports with the bottom
of the plasma display as
indicated in the accompa-
nying diagram.
2
Securing the plasma display with
Installation screws
2
.
Secure them using the enclosed hexagonal wrench.
3
Securing the plasma display with
Installation screws
3
.
Attach the plasma display at the points indicated by the
arrows using the enclosed hexagonal wrench.
Installation screws
3
(M8 x 40 mm: black)
4
Attaching the speakers.
Refer to the operating instructions for the speaker for
the installation method.
Caution
