6
En
On this stand, you can adjust the angle of inclination of the
plasma display within a range of 2° forward or backward
according to your preference.
Note
Be sure to adjust the angle only after you have
attached the plasma display.
Be sure to install it on a flat table or other flat
surface.
Be sure to hold the top of the plasma display
with your hand while adjusting the angle.
Adjustment Procedure
1
Loosen the forward/backward inclination
anchor bolts using the enclosed C wrench.
While being sure to hold the top of the plasma display
with your hand, loosen the
forward/backward
inclination anchor bolts
on the left and right sides by
rotating them upwards using the enclosed C wrench.
2
Set the angle you prefer.
Set the angle you prefer by slowly moving the plasma
display.
3
Tighten the forward/backward inclination
anchor bolts.
Firmly tighten the
forward/backward inclination
anchor bolts
on the left and right sides by rotating
them downward using the enclosed C wrench.
Be sure to hold the top of the plasma display with your
hand until you have fully tightened the bolts.
4
Check once more to make sure that the
forward/backward inclination anchor bolts
are fully tightened.
2
˚
2
˚
Forward/Backward Angle of Inclination Adjustment Mechanism
Forward/backward
inclination anchor bolt
Loosening
Forward/backward
inclination anchor bolt
Tightening
