3
En
English
Checking the Standard Accessories
Check to make sure that you have all the standard accessories before assembly and installation.
• Note that a Phillips screwdriver (not included) is required for assembly.
Base cover x 1
Stand pipes
(left and right, interchangeable) x 2
Screws
(M5 x 10 mm: silver) x 6
Installation bolts
(M6 x 20 mm: black) x 4
Operating instructions
(this document) x 1
Assembling the Stand
Assembly Procedure
1
Turn the base cover over so the underside
is facing up.
Note
When the base cover is turned over, be very careful not
to scratch or damage the front surface of the base cover.
2
Insert the stand pipes into the base cover.
3
Tighten the screws to stabilize the stand
pipes.
Note
Assemble the stand with a soft sheet placed under the
base cover.
If a sheet is not laid before assembly, the front surface of
the base cover may be scratched.
Due to the manufacturing process of the base cover, there
may be a “weld line” exposed in the plastic. Note that this
will not cause any damage to the product, and does not
reflect any flaws in the product design.
Cable clamps x 2
Operating instructions
Mode d’emploi
Table top stand
Pied de table
PDK-1015
Base cover
Screws
(M5 x 10 mm: silver)
Stand pipe
Stand pipe
Screws
(M5 x 10 mm: silver)
Sheet
