12
En
Installation and assembly instructions
(Stand shown below is a 43-inch display stand with short support legs)
1
Slide center support column into brackets on base.
3
Use short hexagonal bolts to attach PDP bracket to
center support column (bolts must be screwed in
four locations).
The bracket may be screwed into the upper holes, middle
holes, or lower holes of the center support column to adjust
the height of the display. The middle holes are designed to be
used for standard installation.
2
Use short hexagonal bolts to fix center support
column into place (4 locations).
Locations of holes on center support column for attach-
ment of PDP bracket.
When installing speakers below the plasma display
Remove the short support legs attached to the PDP bracket
and replace them with the long support legs. (Use the
hexagonal wrench included with the stand to do so.)
When installing speakers below the plasma display, attach the
speakers to the plasma display before attaching the speakers
and display to the stand.
Note
Use the short support legs if speakers are to be installed at the
sides of the plasma display.
Upper
holes
Middle
holes
Lower
holes
Upper
holes
Middle
holes
Lower
holes
Slide into
brackets
Center support
column
Base
Short hexagonal bolts
(M8 x 16 mm)
Short hexagonal
bolts (M8 x 16 mm)
PDP bracket
Slide grooves
into place
Caution
The types of plasma displays which may
be used with the stand differ depending
on the length of the support legs at-
tached to the PDP bracket, so you should
check to see if the display to be attached
is compatible before proceeding.
Long support
legs
PDP ブラケット
Long support
legs
Slide grooves
into place
PDP bracket
