8
En
Preventing Equipment from Falling Over
y
After installing the stand, be sure to take special care to ensure that the equipment will not
fall over.
y
Secure the plasma television to both the rack and the wall surface.
Stabilizing on a rack etc.
Fix the plasma television using the screws (M5 x 15 mm) and falling prevention hardware as shown in
the diagram.
Fix the racks etc. using screws for sale on the market.
Note
To stabilize the equipment on a table,
use screws that have a nominal
diameter of 4 mm and that are at
least 20 mm long.
Min. 20 mm
4 mm
8 mm to 15 mm
Using a wall for stabilization
1. Attaching falling prevention bolt (hook) to the column.
2. Using strong cord to firmly stabilize it appropriately and firmly to a wall, pillar, or other
sturdy element.
Note
Use hook, cord, and fitting that are
available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.
M8
12 mm to 15 mm
1
Hook
2
Cord
Fitting
This illustration shows the case of a
50 inch model (side speaker)
This illustration shows the case of a
50 inch model (side speaker)
Screws
(M5 x 15 mm)
Falling prevention
hardware