21
En
English
Min. 20 mm
(13/16 inch)
6 mm
(1/4 inch)
9 to 15 mm
(3/8 to 5/8 inch)
12 to 15mm
(1/2 to 5/8 inch)
8mm
(3/8 inch)
1
Hook
2
Cord or chain
Fitting
* : 50 inch display model
** : 43 inch display model
120
(4-23/32)
575 (22-21/32)*
500 (19-11/16)**
575 (22-21/32)*
500 (19-11/16)**
24 (1)
356
(14-1/16)
Fixing the rotation to the front
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
Use a screw that has a nominal
diameter of 4 mm (3/16 inch)
and length from 15 to 20 mm
(5/8 to 13/16 inch) to fix the
rotation to the front.
15 to 20 mm
(5/8 to 13/16 inch)
4 mm
(3/16 inch)
7 to 12 mm
(5/16 to 1/2 inch)
Preventing Equipment from Falling Over
Stabilizing on the floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on the
floor use screws that have a
nominal diameter of 6 mm (1/4
inch) and that are at least 20 mm
(13/16 inch) long.
After installing the stand, be sure to take measures so that the equipment will not fall over.
Position of floor screws: Without speakers
Unit: mm (inch)
Using a wall for stabilization
(43 inch display model in the figure)
1
Attaching falling prevention bolts (hooks)
to the plasma display.
2
Using strong cords or chains to firmly
stabilize it to a wall, pillar, or other sturdy
element.
Perform this work in the same way on the left and
right sides.
The length of the cords or chains used must be long
enough to allow the stand to rotate freely.
Note
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended hook:
Nominal diameter 8 mm (3/8 inch)
Length 12 to 15 mm (1/2 to 5/8 inch)
