Preparation
05
19
En
English
Attaching the ferrite core
To help prevent noise, attach the supplied ferrite core to the connector
end of the power cord as shown. Use the supplied cable tie to prevent
the ferrite core from slipping on the cable.
Note
• Disconnect the power cord from the power outlet when the plasma
television is not going to be used for a long period of time.
Connecting the power cord
Preparing the remote control unit
Inserting batteries
1 Open the battery cover.
2 Load the supplied two AA size batteries while inserting their
respective negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+) and (–)
indicators in the battery compartment.
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline ones.
• Place the batteries with their terminals corresponding to the (+)
and (–) indicators.
• Do not mix batteries of different types. Different types of batteries
have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can
shorten the life of new batteries or cause chemical leakage in old
batteries.
• Remove batteries as soon as they have worn out. Chemicals that
leak from batteries can cause a rash. If you find any chemical
leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life
expectancy due to storage conditions.
• If you will not use the remote control unit for an extended period of
time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY
WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL
PUBLIC INSTITUTION’S RULES THAT APPLY IN YOUR
COUNTRY/AREA.
1
2
3
4
Ferrite core
Cable tie
AC power cord
To power outlet
As close as possible
Europe, except UK and
Republic of Ireland
UK and Republic of Ireland
Power cord
Rear view
PDP4270XD_En.book Page 19 Friday, June 16, 2006 5:32 PM
