29
En
Basic Adjustment Settings
09
English
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the two Energy Save modes to save power
consumption.
1
Press
HOME MENU
.
2
Select “Power Control” ( / then
ENTER
(ENTER/DISP.)
).
3
Select “Energy Save” ( / ).
4
Select “Save 1” or ”Save 2” ( / ).
5
Press
HOME MENU
,
INPUT
1
to
INPUT
6 (INPUT)
to exit
the menu.
No Signal off
The Plasma Display will be automatically placed into the
standby mode if no signal is received for 8 minutes.
1
Press
HOME MENU
.
2
Select “Power Control” ( / then
ENTER
(ENTER/DISP.
).
3
Select “No Signal off” ( / ).
4
Select ”Enable” ( / ).
5
Press
HOME MENU
,
INPUT
1
to
INPUT
6 (INPUT)
to exit
the menu.
NOTE
• INPUT1 to INPUT6 are enabled. INPUT1 and 4 are disabled,
however, when they have “Signal Type” set to “PC.”
• Operation is disabled during display of the HOME MENU.
• A message will be displayed immediately before the Plasma
Display enters standby mode.
Power Management
The Plasma Display will be automatically placed into the
standby mode when no signal is received.
1
Press
HOME MENU
.
2
Select “Power Control” ( / then
ENTER
(ENTER/DISP.)
).
3
Select “Power Management” ( / ).
4
Select “Enable” ( / ).
5
Press
HOME MENU
,
INPUT
1
to
INPUT
6 (INPUT)
to exit
the menu.
NOTE
• INPUT1 and INPUT4 only are enabled. However, when
“Signal Type” is set to “AV”, they are disabled.
• Operation is disabled during display of the HOME MENU.
Item
Description
Standard
Does not decrease the picture brightness.
Save1
Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2
Decreases the picture brightness and lowers
power consumption.
Item
Description
Disable
Does not place the Plasma Display into the
standby mode.
Enable
Places the Plasma Display into the standby
mode if no signal is received for 8 minutes.
Item
Description
Disable
No power management
Enable
If no input signal is detected for one minute or
more, the unit automatically enters the standby
mode. If a signal is subsequently detected, the
unit automatically turns ON.
