5
English
English
NOTE:
•
Press the lever and insert the end of
the cable.
•
When you release the lever, it clamps
onto the speaker cable.
Caution
•
Be sure to turn the connected devices off and remove
the power cord from the wall outlet beforehand when
changing the connection or installation method.
•
If you insert the speaker cable too far so
that the insulation is touching the speaker
terminal, you may not get any sound.
Please insert it with showing the copper
wire.
•
Check if the end of the speaker cables are securely
connected to the terminals by slightly tugging on the
cable after making connections. Loose connections
may result in sound dropouts or noise.
•
If there is a short in the
and
cables caused by an
exposed lead wire, excessive load may be applied to
the plasma television, resulting in interrupted operation
or malfunction.
•
Incorrect connections of the speaker cable to the right
or left of the plasma television terminals with respect
to the polarity may result in insufficient stereo sound
effects, delivering poor bass sounds or unstable sound
image.
•
Bundle the cable without pulling.
For illustrative purposes, the table top stand is not presented here.
Black
Gray
Speaker terminal
Speaker terminal
Speaker cable
Speaker terminal
Gray
Gray
Black
Black
Red
Red
Connecting the speaker cables
to the rear of plasma television.
Connect the cables correctly with respect to
the polarity of the plasma television speaker
terminals, that is,
cable (Gray) to
terminals (Red) and
cable (Black) to
terminals (Black).
Connecting the speaker cables
to the speaker.
Connect the cables correctly with respect to
the polarity of the speaker terminals, that is,
cable (Gray) to
terminals (Red) and
cable (Black) to
terminals (Black).
Red
Black
