50
PDU-50WX2
Fig. 1 PC Board Location (rear side view)
DIGITAL VIDEO
Assy
X DRIVE
Assy
Y DRIVE
Assy
INTERFACE Assy
SW POWER SUPPLY
Module
6.2 ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
INTERFACE Assy
When repaired
When replaced
DIGITAL VIDEO Assy
When repaired
No adjustment required.
When replaced
SW POWER SUPPLY Module
When replaced
No adjustment required.
No adjustment required.
No adjustment required.
1. Remove IC1204 (24LC04(1) SN-TBB) from the former PC
Board to replace, and install it to the new PC Board.
2. When use new Assy which replaces it and recovered as
service parts once again, replace IC1204 with new IC.
Y DRIVE Assy
When repaired
When replaced
1. VOFS/VH/IC5V voltage adjustment
2. Timing adjustment of pulse module
1. SUSB ground timing adjustment
2. Panel white balance adjustment
1. SUSB ground timing adjustment
2. Panel white balance adjustment
X DRIVE Assy
When repaired
When replaced
1. VRN voltage adjustment
2. Timing adjustment of pulse module
Summary of Contents for PDU-50WX2
Page 23: ...PDU 50WX2 23 ...
