10
Operation
02
Removing the cartridge
1 Turn the headshell lock nut and remove the headshell.
2 Loosen the cartridge mount screws and remove them.
3 Disconnect the lead wires on the cartridge side.
Attaching the cartridge
1 Connect the lead wires.
They are color-coded as shown below. Be careful to connect them properly.
Color
Function
Red
Right channel (R)
White
Left channel (L)
Green
Right channel ground (RG)
Blue
Left channel ground (LG)
Upside
R
L
RG
LG
(Backside of cartridge)
2 Attach the cartridge.
To achieve the required overhang, mount in such a way that the stylus tip is positioned about 45 mm from the
edge of the headshell’s mount surface (the rubber washer), as shown on the diagram below.
!
The overhang for this player should be 19 mm.
Back side
45 mm
(1 3/4 in.)
Mount parallel.
Front side
Mount perpendicular.
3 Tighten the cartridge mount screws to mount the cartridge.
Notes
!
After replacing the cartridge, be sure to readjust the horizontal balance, stylus pressure, and anti-skating
value.
!
The thickness of the terminal depends on the replacement cartridge, and some may not connect securely. In
this case, use the included spare lead wire.
Summary of Contents for PL-30-K
Page 25: ......