2
Switching the seek mode
=
For details, refer to this page.
3
Tuning in strong signals
=
For details, refer to this page.
4
Switching the reception mode
=
For details, refer to this page.
Storing the strongest broadcast
frequencies
“
BSM
”
(best stations memory) lets you auto-
matically store the six strongest broadcast fre-
quencies under the preset tuning keys [
P1
] to
[
P6
] and, once stored there, you can tune in to
these frequencies with the touch of a key.
%
Touch [Start] to turn BSM on.
BSM
begins to flash. While
BSM
is flashing,
the six strongest broadcast frequencies will be
stored under the preset tuning keys [
P1
] to
[
P6
] in order of their signal strength. When
this is complete,
BSM
stops flashing.
p
To cancel the storage process, touch
[
Stop
].
p
Storing broadcast frequencies with
BSM
may replace broadcast frequencies you
have already saved by using [
P1
] to [
P6
].
Switching the seek mode
You can select the method of seek tuning.
%
Touch [Seek] to select the desired set-
ting.
!
[
All
]:
Seeks stations from both analog and digital
broadcasting.
!
[
HD
]:
Seeks from digital broadcasting only.
p
If you select
“
HD
”
on this setting while
[
Blending
] is set to
“
Analog
”
, the setting
on [
Blending
] turns to
“
Digital-Analog
auto
”
automatically.
Tuning in strong signals
Local seek tuning allows you to tune in only
those radio stations with sufficiently strong
signals for good reception.
1
Touch [On] to turn local seek tuning on.
To turn local seek tuning off, touch [
Off
].
2
Touch [
c
Prev] or [Next
d
] to set the sen-
sitivity.
There are four levels of sensitivity for FM and
two levels for AM:
FM:
1
—
2
—
3
—
4
AM:
1
—
2
p
The FM
“
4
”
(AM
“
2
”
) setting allows recep-
tion of only the strongest stations, while
lower settings let you receive weaker sta-
tions.
Switching the reception mode
If a digital broadcast reception condition gets
poor, the tuner automatically switches to the
analog broadcast of the same frequency level
in default. If you want to prevent a frequent
automatic switching, switch this setting to
[
Analog
].
%
Touch [Blending] to switch the recep-
tion mode.
!
[
Analog
]:
Receives analog broadcasting only.
!
[
Digital-Analog auto
]:
Automatically switches to the analog broad-
cast of the same frequency level as the digi-
tal broadcast.
p
If you select
“
Analog
”
on this setting while
[
Seek
] is set to
“
HD
”
, the setting on [
Seek
]
turns to
“
All
”
automatically.
Using the HD Radio (
Digital Radio
)
En
105
Chapter
19
Using
the
HD
Radio
(
Digital
Radio
)