31
PRV-LX10
En
English
System Default Settings
System Information
Go to
SET UP
section
=
[
System
]
=
[
Information
]
to confirm the following system information:
System version (application version / OS version)
Total power-on time (hours)
Hard disk drive (HDD) access time (hours)
DVD-R/RW Drive read/write time (hours)
Service information
SET UP section
=
[System]
=
[Information]
Note:
The number in service Information [
Service Info
]
indicates the result of hard disk fault diagnosis.
0
Hard disk is operating normally.
1
,
2
Hard disk operation requires caution.
3
,
4
The hard disk may crash. Take it back to the
dealer’s at the earliest possible opportunity.
This information is only a guideline. Contact your
dealer when the hard disk does not seem to run
normally regardless the information that appears. Do
not leave important data on the hard disk but save it
to a DVD-R/RW as DVD-Video disc.
HDD Tools
The
SET UP
section
=
[
System
]
=
[
HDD Tools
]
command allows you to format and perform file
checks of the video recording area on the hard disk
and the USB HDD.
Use the [
Target Drive
] command to specify the
drive where the operation is to be performed.
Formatting deletes all data on the drive so be sure to
enter the correct drive in the [
Target Drive
] setting.
Note:
The Delete and Format commands provided with
the unit
do not completely delete
all data on a
hard disk.
Thus discarding or transferring a USB HDD to a
third party when hard disk data has been deleted
using these functions runs the risk of placing
backed up image data into the wrong hands. To
prevent such a risk, use commercially available
software to wipe the hard disk clean or request
a dealer to do so. Consult your USB HDD
manufacturer for details.
SET UP section
=
[System]
=
[HDD Tools]
Note 1:
Selecting Format deletes all projects and image files
on the hard disk. The Format command erases even
those clips in projects which have been set for
accidental erasure protection using the
EDIT
section
=
[
Project
]
=
[
Record/Name
]
=
[
Protect
]
command. Also, when executing the Format
command, set drive selection to
“HDD”
(see page
35) (formatting cannot be performed on
“DVD1”
and
“DVD2”
).
Note 2:
The internal hard disk drive cannot be formatted
when there is a disc in the drive. Remove the disc to
format the hard disk drive.
Note 3:
[
USB hard disk
] appears as [
Target Drive
]
command only when a USB HDD is connected
before opening the
Function Menu
.
Note 4:
When using a USB HDD, connect the hard disk
before turning on the unit. A USB HDD equipped
with a power switch should be turned on before
turning on the unit. Do not connect and disconnect
the USB cable when the unit is in operation.
When connecting the UPS to the PRV-LX10, be sure
to disconnect the power to the PRV-LX10 first, and
use the cord supplied with the UPS to connect the
two units. If the connection is made after the PRV-
LX10 has booted up, the shut-down operation may
not occur properly.
Before using the unit with a UPS, be sure to consult
the operating instructions accompanying the UPS
product.
