34
PRV-LX10
En
Selecting Input
On the
Function Menu
, the
STATUS
section
=
[
V
Input
] and [
A Input
] commands indicate the
currently selected video and audio input signals. Use
the
CURSOR
and
ENTER
buttons to change to the
connectors for different input signals if desired.
With either [
V input
] or [
A input
] is designated in
“DV”
, both video and audio will become DV input. In
this case,
“LPCM”
(see page 37) cannot be selected
as the audio encoding method.
When
“PAL”
is selected as the TV system, only 1
[
Component
] type will be available.
Also, DV audio format auto-sensing is performed in
the case of the following settings, with the result
that recording and preview are disabled during the 2
or 3 seconds until the sensing is completed.
1
When input selection is changed;
2
When recording settings are changed;
3
Immediately following DV signal input (when
cable is connected or playback is begun on a
connected DV component)
Note:
If preview is performed immediately after setting
input, the error message
“No DV Input”
will appear.
This is only the result of the auto-sensing process
noted above, however, and is not a malfunction.
STATUS section
=
[V Input]
STATUS section
=
[A Input]
Recording
TV system switch confirmation dialog 1
When [
OK
] is selected, the TV system changes and
a second confirmation dialogue box appears.
TV system switch confirmation dialog 2
Press [
OK
] to confirm the newly selected TV system.
If [
Cancel
] is selected, the unit will return to the
previously set TV system. Also, the previous TV
system will also be restored automatically if the
dialogue box is left displayed without taking action
for 10 seconds or more.
The TV system can also be changed by
simultaneously pressing the front panel’s
CURSOR
(upward pointing arrow) and
STOP
buttons,
or by pressing function key 1-12 if that function has
been allocated. In this case, no dialogue box will be
displayed.
Note :
TV system cannot be changed except when the unit
is in the idle mode.
