23
En
Operation
English
Operation
3
OFF
ON
2
Automatic power-off
(POWER MANAGEMENT)
This display is equipped with [POWER MGT.] function,
which allows the unit to automatically switch to standby
mode when no sync signal is detected.
(A warning message is displayed before this function
operates.)
Note
Always turn off the Plasma Display’s main power switch when
not using the display for extended periods of time.
2
Use the
2
/
3
buttons to select [SETUP].
M E N U
I N P U T 1
CHANGE
SET
EXIT
MENU
S C R E E N
S E T U P
O P T I O N
P O W E R M G T.
: O F F
S I G N A L F O R M AT
P I C T U R E
3
Press the SET button to confirm selection of
[POWER MGT.].
The factory default setting is [OFF].
Each time the button is pressed, the setting alternates
as follows:
÷
OFF ..... The display will continue in operating mode,
regardless of the presence/absence of an
input sync signal.
÷
ON ....... If a sync signal is not detected, a warning
message is first displayed for 8 seconds,
after which the display automatically enters
the standby mode, and the STANDBY/ON
indicator flashes green. If a sync signal is
input again later, the Plasma Display
automatically returns to normal operating
mode (*1).
*1. Except when input signal is G ON SYNC or
composite SYNC
4
When the setup is finished, press the MENU
button to exit the menu screen.
Note
The [POWER MGT.] function must be set individually for each
input (INPUT1 or INPUT2).
To return to operating mode:
To return to normal operation from the [POWER MGT.]
function’s standby mode, either operate your computer,
or press the
INPUT
button.
MENU
SET
2
/
3
INPUT
1
Press the MENU button to display the menu
screen.
S C R E E N
S E T U P
O P T I O N
:
0
:
0
:
0
C O N T R A S T
:
0
B R I G H T N E S S
H . E N H A N C E
V. E N H A N C E
P I C T U R E R E S E T
P I C T U R E
M E N U
I N P U T 1
ENTER
SET
EXIT
MENU
STANDBY/ON
MENU
DISPLAY
/ SET
– VOL +
INPUT SCREEN SIZE
2
/
3
INPUT
MENU SET
Remote control unit
Main unit operating panel
