NOTE:
The device could comply with the local national regulations.
•
1
n Canada, it should comply with CAN ICES-3(B)/NMB-3(B).
e In USA, this device complies with part
15
of the FCC Rules. Operation is subject to the
following two conditions:
(1)
This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part
15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
.connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
.consult the dealer or an experienced radio/TV technician for help.
.changes or modifications not approved by the party responsible for compliance could
void user'S authority to operate the equipment.
＠
—
/
I
Indicators on LCD
I
Mode display
Displays the current operation mode. Including
auto(U), cool(*), dry((i), heat(今'if-"=) (be
applicable to cooling & heating models only ),
fan(含） and back to auto(U ).
Transmission Indicator
This transmission indicator lights when remote
controller transmits signals to the indoor unit.
ON/OFF display
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
-—-
厂：：
I
勹
：：
：
二
勺
E
:
：
1
:
：
a
ctvated
Displays the temperature setting(62
°
F-86
°
F). When
you set the operating mode to FAN, no temperature
setting is displayed. And if in the TIMER mode, shows
the ON and OFF settings of the TIMER.
Fan speed display
Displays the selected fan speed, AUTO(no display)
and three fan speed levels "六"(LOW) 00Y.:,,::,,t,'!E;-n
(MED) "�; 书总总盘令牙:,... (HIGH) can be indicated.
The fan speed is AUTO when the operating mode is
either AUTO or DRY.
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the
display window.
@
—
