background image

3

En

English

Before you start

• The nominal impedance of this speaker system is 6 

Ω

Connect the speaker system to an amplifier with a load 
impedance ranging from 6 

Ω

 to 16 

Ω

 (a model with “6 

Ω

16

Ω

” displayed on the speaker output terminals).

In order to prevent damage to the speaker system resulting 
from input overload, please observe the following precautions:

• Do not supply power to the speaker system in excess of the 

maximum permissible input.

• When using a graphic equalizer to emphasize loud sounds in 

the high-frequency range, do not use excessive amplifier 
volume.

• Do not try to force a low-powered amplifier to produce loud 

volumes of sound (the amplifier’s harmonic distortion will be 
increased, and you may damage the speaker).

Caution: installation

• When placing this unit, ensure that it is firmly secured and 

avoid areas where it may be likely to fall and cause injury in the 
event of a natural disaster (such as an earthquake).

• Do not attach these speakers to the wall or ceiling. They may 

fall off and cause injury.

• Do not install your speakers overhead on the ceiling or wall. If 

improperly attached, the speaker grille can fall and cause 
damage or personal injury.

• Switch off and unplug your AV equipment and consult the 

instructions when connecting up components. Make sure you 
use the correct connecting cables.

Caution: in use

• Do not place the speaker on an unstable surface. It could 

present a hazard if it falls, as well as damaging the equipment.

• Do not use the speaker to output distorted sound for long 

periods of times. This can result in a fire hazard.

• Do not sit or stand on the speaker, or let children play on the 

speaker.

• Do not put large or heavy objects on top of the speaker.

• Do not place magnetic objects such as screwdrivers or iron 

parts near the tweeter or midrange. Since the speakers use 
strong magnets, the objects may be attracted, causing injury 
or damaging the diaphragm.

For U.S. model

For European model

What’s in the box

Spikes (with attached nuts) x 4

Spike bases x 4

Auxiliary feet x 2

Non-skid pads x 4

Grille x 1

Operating instructions

WARNING:

 Handling the cord on this product or 

cords associated with accessories sold with the 
product will expose you to chemicals listed on 
proposition 65 known to the State of California and 
other governmental entities to cause cancer and 
birth defect or other reproductive harm.

 

D36-P4_A_En

Wash hands after handling

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used 
electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to 
designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential 
negative effects on the environment and human health.

K058_A_En

S-4EX_EN.book  3 ページ  2008年7月16日 水曜日 午後2時2分

Summary of Contents for S-4EX






Reviews: