background image

 

Non-skid pads

 

Attach the non-skid pads to the base of the speakers. Use the 
supplied adhesive to attach 4 pads to the base (flat surface) of each 
speaker.

 

 

 

Cabinet maintenance

 

Use a polishing cloth or dry cloth to wipe off dust and dirt.

If the cabinet is very dirty, clean with a soft cloth dipped in some 
neutral cleanser diluted five or six times with water, and then wipe 
again with a dry cloth. Do not use furniture wax or cleaners. 

Never use thinners, benzene, insecticide sprays and other 
chemicals on or near the cabinets, since these will corrode the 
surfaces.

 

Wall-mounting the front and surround speaker 
system

 

Attaching the brackets

 

• Make sure to tighten the supplied screw as securely as possible 

when attaching the bracket to the back of the speaker.

• Please do not attach the brackets to the center speaker.

 

Before mounting

 

• Remember that the speaker system is heavy and that its weight 

could cause the wood screws to work loose, or the wall material 
to fail to support it, resulting in the speaker falling. Make sure 
that the wall on which you intend to mount the speakers is 
strong enough to support them. Do not mount on plywood or 
soft surface walls.

• Mounting screws are not supplied. Use screws that are suitable 

for the wall material and that will support the weight of the 
speaker.

 

 Note

 

• If you are unsure of the qualities and strength of the walls, 

consult a professional for advice.

• Pioneer is not responsible for any accidents or damage that 

result from improper installation.

 

Troubleshooting

 

 Caution

 

• These speakers are equipped with a protection device to protect 

the transducers from extreme conditions. Under these 
conditions the protection device will activate and stop the 
speaker from producing sound. If this happens turn the volume 
down to resume normal speaker output. 

 

Specifications

 

Front / Surround / Surround back speakers

 

Enclosure  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Closed-box bookshelf type

(magnetically shielded)

System. . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.7 cm 1-way system Speakers
Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm cone type
Nominal impedance  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 

    

 

Frequency range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85 Hz to 20 kHz
Dimensions. . . . . . . . . . . . . . . . . . . . . . . .105 (W) x 115 (H) x 114 (D) mm
Weight
Front speakers  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.6 kg
Surround speakers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.66 kg
Surround back speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.66 kg

 

Center speaker

 

Enclosure  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Closed-box bookshelf type 

(magnetically shielded)

System. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm 1-way system
Speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7.7 cm cone type
Nominal impedance  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 

    

 

Frequency range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 Hz to 20 kHz
Dimensions. . . . . . . . . . . . . . . . . . . . . . . . .270 (W) x 90 (H) x 100 (D) mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.8 kg

 

Note: Specifications and design subject to possible modification 
without notice due to improvements. 

5 – 7 mm

Mounting screw  
(not supplied)

Bracket screw  
(supplied)

5 mm

10 mm

 

Symptom

Possible cause

Remedy

 

No sound

• Bad speaker wire or 
connection
• Receiver is off
• Volume control is at 
zero

• Connect correctly or 
replace wire.
• Turn on receiver.
• Slowly turn up volume.

Sound is 
distorted

• Extreme signal 
condition

• Turn down the 
amplifier’s output level 
(volume, bass control, 
bass boost) to lower the 
level.

Speakers stop 
producing 
sound suddenly

• Extreme signal 
condition for extended 
period of time

• Turn the volume down 
to resume normal 
speaker output. 

01 speaker system.fm 3 ページ 2005年7月8日 金曜日 午後2時22分

Summary of Contents for S-STP600

Page 1: ...n Making receiver settings Before connecting the speakers please read the Operating Instructions supplied with your VSX 515 or VSX 815 receiver to make the following settings Switch the speaker impedance to the 6Ω setting see Switching the speaker impedance to do this Set the crossover frequency to 200Hz see Crossover network to do this After connecting the speakers please complete Using the Quick...

Page 2: ...out of your room the surround left and right speakers may be mounted on the side walls with the surround back speaker mounted on the rear wall The surround back speaker should be placed directly behind your listening position for best performance Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen Important Do not attach the center...

Page 3: ...responsible for any accidents or damage that result from improper installation Troubleshooting Caution These speakers are equipped with a protection device to protect the transducers from extreme conditions Under these conditions the protection device will activate and stop the speaker from producing sound If this happens turn the volume down to resume normal speaker output Specifications Front Su...

Page 4: ...A TEL 800 421 1404 PIONEER ELECTRONICS OF CANADA INC 300 Allstate Parkway Markham Ontario L3R OP2 Canada TEL 1 877 283 5901 PIONEER EUROPE NV Haven 1087 Keetberglaan 1 B 9120 Melsele Belgium TEL 03 570 05 11 PIONEER ELECTRONICS ASIACENTRE PTE LTD 253 Alexandra Road 04 01 Singapore 159936 TEL 65 6472 7555 PIONEER ELECTRONICS AUSTRALIA PTY LTD 178 184 Boundary Road Braeside Victoria 3195 Australia T...

Reviews: