#
You can adjust the parameters for other
speaker units (filters) in the same way.
10 Press BAND/ESC to cancel the network
adjustment mode.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to this unit, turn the sub-
woofer output on.
The subwoofer output phase can be switched
between normal and reverse.
1 Use MULTI-CONTROL to select SW 1.
The function name tag
SW 1
is highlighted.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
Sub. W Normal
appears in the display. Sub-
woofer output is now on.
#
To turn subwoofer output off, press
MULTI-CONTROL
again.
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push
MULTI-CONTROL
left to select reverse
phase and
Sub. W Reverse
appears in the dis-
play. Push
MULTI-CONTROL
right to select
normal phase and
Sub. W Normal
appears in
the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select SW 2.
The function name tag
SW 2
is highlighted.
#
When the subwoofer output is on, you can se-
lect
SW 2
.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each pushing
MULTI-CONTROL
left or right
selects cut-off frequencies in the following
order:
50
63
80
100
125
160
200
(Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each pushing
MULTI-CONTROL
up or down
increases or decreases the level of the sub-
woofer.
+6
24
is displayed as the level is in-
creased or decreased.
Adjusting lowpass filter
attenuation slope
When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1 Use MULTI-CONTROL to select SW 3.
The function name tag
SW 3
is highlighted.
#
When the subwoofer output is on, you can se-
lect
SW 3
.
2 Push MULTI-CONTROL left or right to
select slope.
Each pushing
MULTI-CONTROL
left or right
selects slopes in the following order:
18
12
6
(dB/oct.)
Note
When slope of subwoofer and high pass filter are
-12dB
, and same cut-off frequency, the phase is
reversed 180 degrees at the cut-off frequency. In
this case, reversing the phase assures improved
sound continuity.
Audio Adjustments
En
60
Section
12
