Listening to the radio
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step
on page 27).
1
Band indicator
Shows which band the radio is tuned to, AM
or FM.
2
Frequency indicator
Shows to which frequency the tuner is
tuned.
3
Stereo (
5
) indicator
Shows that the frequency selected is being
broadcast in stereo.
4
Preset number indicator
Shows what preset has been selected.
1 Press SOURCE to select the tuner.
Press
SOURCE
until tuner is selected as the
source.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND to select a band.
Press
BAND
until the desired band is dis-
played,
F1
,
F2
,
F3
for FM or
AM
.
4 To performmanual tuning, press
c
or
d
with quick presses.
The frequencies move up or down step by
step.
5 To performseek tuning, press and hold
c
or
d
for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
#
You can cancel seek tuning by pressing either
c
or
d
with a quick press.
#
If you press and hold
c
or
d
you can skip
broadcasting stations. Seek tuning starts as soon
as you release the buttons.
Note
When the frequency selected is being broadcast
in stereo the stereo (
5
) indicator will light.
Tuner
En
9
English
Section
04
