−
16
−
English
Recommended Installation Position on Rear Windscreen
When installing this product on the rear windscreen, installation in a vehicle and in a position that
satisfies all of the following conditions is recommended.
• A position where the lens part of this product is within the wiping range of the wiper.
• A position where this product faces in the horizontal direction to the rear and to the sides.
• A position where the lens part of the product and the double-sided tape do not overlap the heating
wires.
• A position where cables can be routed without unnecessary force.
This product
Rear windscreen
Power cable
Heating wires
Wiping range of the rear wiper
1 Clean the installation area of dirt and oils using the included cleaning cloth.
Front windscreen
Rear windscreen
2 Install the GPS unit on to this product.
Align the tab on the GPS unit and the groove on this product, check that the terminals are aligned,
then install by firmly pressing until it clicks.
Tab
Groove
Terminals
CAUTION
Do not exert undue force when the terminals are not aligned. Doing so may cause damage.