Additional information
12
71
En
Remote control
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the TONE button, press and
hold the
STANDBY/ON button for about three
seconds.
3
When you see RESET? appear in the display,
press ENTER.
OK?
shows in the display.
4
Press SYSTEM SETUP to confirm.
OK
appears in the display to indicate that the receiver
has been reset to the factory default settings.
Switching the speaker impedance
We recommend using speakers of 8
Ω
with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω
impedance rating.
•
With the receiver in standby, press
STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
•
SP 6 OHM
– Use this setting if your speakers are
rated at 6
Ω
.
•
SP 8 OHM
– Use this setting if your speakers are
rated at 8
Ω
or more.
Symptom
Cause
Remedy
Cannot be remote controlled.
• The remote control batteries have worn out. • Replace the batteries (see
Loading the batteries
on
page 7).
• Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote
sensor on the front panel (see
Operating range of remote
control unit
on page 30).
• There is an obstacle between the receiver
and the remote control.
• Remove the obstacle or move to another place.
• Strong light such as fluorescent light is
shining onto the unit's remote control sensor.
• Avoid exposing the remote sensor on the front panel to
direct light.
• Something is plugged into the
CONTROL IN
jack.
• Unplug the cable from the
CONTROL IN
jack and use
remote normally (see
Operating other Pioneer components
on page 23).
Other components can't be
operated with the system
remote.
• The preset code settings are wrong.
• The batteries wore out and the system
settings were cleared.
• Input the correct preset code.
• Reset the proper system settings.
The SR cable is connected, but
the connected components can’t
be operated with the remote.
• The SR cable hasn't been connected
properly.
• Reinsert the SR cable, making sure it’s connected to the
right jack (see
Operating other Pioneer components
on
page 23).
• The rest of the component connections
have not been made.
• Make sure an analog connection has been made
between the units.
• The component you have hooked up is not a
Pioneer product.
• This feature only works with Pioneer products.
VSX_1015.book.fm 71 ページ ２００４年１１月２９日 月曜日 午後２時３８分
