57
VSX-709RDS, VSX-609RDS
8.1 PANEL FACILITIES
8. PANEL FACILITIES AND SPECIFICATIONS
Front Panel
This illustration shows the VSX-709RDS model.
1
—
OFF/
_
ON (Main power) button
If the button is OFF (
—
), the power of the receiver is shut off
and the STANDBY/ON button (
3
) on the receiver or the
remote control do not function. Pressing the button again
will turn the receiver ON (
_
) and the receiver enters the
standby mode. In the standby mode, you can turn on the
receiver using the STANDBY/ON button (
3
) on the receiver
or the remote control.
2
STANDBY indicator
Lights when the receiver is in standby mode (note that the
receiver consumes a small amount of power (1 W) in
standby mode).
3
STANDBY/ON button
Switches the receiver between on and standby (note that
the receiver consumes a small amount of power (1 W) in
standby mode).
Switches between station memory and frequency select
modes.
Selects station memories when using the tuner.
Selects the frequency when using the tuner.
Switches between the three banks (classes) of station
memories.
6
MEMORY button
Press to memorize a station for recall using the STATION
(+/–) buttons.
7
RF ATT button
Use to lower the input level of a radio signal that is too
powerful or contain interference thus causing the receiver to
distort
8
CHARACTER/SEARCH button
Use to search for different program types in RDS mode. It is
also used to input station names.
9
DIRECT button
Use to switch Direct playback on or off. This mode
bypasses the tone controls and channel levels for the most
accurate reproduction of a program source.
0
BASS (+/–) buttons
Use to increase/decrease bass (within a range of – 6 dB to
6 dB in 2 dB steps).
-
Display
=
TREBLE (+/–) buttons
Use to increase/decrease treble (within a range of – 6 dB to
6 dB in 2 dB steps).
~
MIDNIGHT button
Use when listening to movie soundtracks at low volume.
This feature will enable you to hear quiet sounds and not
get jolted by loud or sudden sound effects.
!
Remote sensor (
Î
)
Receives the signals from the remote control.
@
DSP MODE button
Use to switch between the various DSP modes available
(HALL1, HALL 2, JAZZ, DANCE, THEATER1, THEATER
2) and DSP off. Use to create different surround sound
effects from any stereo source.
#
2
/DTS button
Use to switch between the various Dolby/DTS surround
modes.
$
SIGNAL SELECT button
Use to select between an analog or digital signal.
%
MASTER VOLUME
Use to set the overall listening volume.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
