Bluetooth
® Audio playback
32
En
10
Note
• This unit will be displayed as “X-CM32”, “X-CM325” or “X-
CM42” on all
Bluetooth
capable devices that you have.
Pairing will start.
• Place the
Bluetooth
capable device close to the unit.
• Please refer to the user’s manual for your
Bluetooth
capable device for details on when pairing can be
performed and the procedures required for pairing.
• When PIN code entry is requested, enter “
0000
.” (This
unit does not accept any PIN code setting other than
“
0000
.”)
4
Confirm on the
Bluetooth
capable device
that pairing has been completed.
If pairing with the
Bluetooth
capable device has been
completed correctly, the name of the
Bluetooth
capable
device will be displayed on the front panel of the unit. (Only
single-byte alphanumeric characters can be displayed. Any
character that cannot be displayed will be indicated by a “*”.)
Listen to music on the unit from a
Bluetooth
capable device
1
Press the BT AUDIO.
The unit will switch to
BT AUDIO
input.
2
A
Bluetooth
connection will be created
between the
Bluetooth
capable device and the
unit.
Procedures for connecting to the unit should be performed
from the
Bluetooth
capable device.
• Please refer to the user’s manual for your
Bluetooth
capable device for details of the connection procedures.
3
Playback music from the
Bluetooth
capable
device.
Note
• When
Bluetooth
capable devise is not connected and no
operations have been performed for more than 20
minutes, the unit will automatically power off. In this
case it is required that the Auto power off is switched to
ON
.
• Auto power off can be switched to
ON
/
OFF
(page 38).
BT STANDBY
• The following can be done when the unit is on standby
with the
BT STANDBY
switched
ON
.
• By selecting a
Bluetooth
capable device that already has
a connection history (pairing has already been
conducted) with this unit, this unit will automatically
turn on with the
BT AUDIO
function.
BT STANDBY settings
• Switch
ON
/
OFF
by long pressing the
INPUT
button
located on the top of the unit for 3 seconds.
• When the power is ON, long press the
INPUT
button.
This cannot be operated if the power is not on.
• The setting operation can only be performed by using the
INPUT
button on the unit. The setting cannot be
performed using the remote control.
Note
• When the
BT STANDBY
is
ON
, “BT STANDBY ON” is
displayed on the main display.
• When the
BT STANDBY
is
OFF
, “BT STANDBY OFF” is
displayed on the main display.
Connection while in BT STANDBY mode with
Bluetooth
capable device
When connection history (pairing has already been
conducted) with a
Bluetooth
capable device exists for the unit
during
BT STANDBY
, the unit can receive a connection
request directly from the connection history.
The unit will start using the
BT AUDIO
function, and connect
with a
Bluetooth
capable device.
Even devices that have already been paired with this unit will
not connect during
BT STANDBY
in the following cases.
In such cases, delete pairing history from the
Bluetooth
wireless technology device and perform pairing again.
• Up to 8 pairing history can be recorded with this unit. If
connecting to a
Bluetooth
wireless technology device
over 8 units, the oldest pairing history will be deleted.
• If the settings are reset to the factory setting, all pairing
history will be deleted.
X-CM32_VXE8_En.book 32 ページ ２０１４年３月１２日 水曜日 午後２時５２分
