USB playback
07
22
En
Chapter 7:
USB playback
Playing USB storage devices
It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be
supplied to a USB storage device. Also note that Pioneer
will accept no responsibility whatsoever for loss of files
on USB storage devices caused by connection to this
unit.
1
Press USB as the input source.
“
USB
/
IPOD
” is shown on the main display.
2
Connect the USB storage device.
The number of folders or files stored on the connected USB
storage device appear on the main display automatically.
• This receiver does not support a USB hub.
• If an iPod/iPhone/iPad mini is connected to the unit, the
unit will automatically begin charging it.
3
When the recognition is completed, press
to start playback.
• When changing to a different input source, stop the USB
memory playback first, before changing.
4
Disconnect USB storage device from the
iPod/iPhone terminal.
Turn the power off before removing the USB storage device.
Note
• USB flash drive that supports USB 2.0 can be used.
• This unit may not recognize a USB storage device, play
files or supply power to a USB storage device. For
details, see
When a USB storage device is connected
on
page 32.
• When a USB storage device is not playing and no
operations have been performed for more than 30
minutes, the unit will automatically power off.
Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press
REPEAT
repeatedly until “RPT ONE” appears. Press
ENTER
.
To repeat all tracks:
Press
REPEAT
repeatedly until “RPT ALL” appears. Press
ENTER
.
To repeat desired tracks:
Perform steps 1 to 5 in “Programmed play (CD or MP3/WMA)”
section on next page and then press
REPEAT
repeatedly until
“RPT ALL” appears. Press
ENTER
.
To cancel repeat play:
Press
REPEAT
repeatedly until “RPT OFF” appears. Press
ENTER
.
Note
• After performing repeat play, be sure to press
.
Otherwise, the file of USB storage device will play
continuously.
• During repeat play, random play is not possible.
Random play
The file of USB storage device can be played in random order
automatically.
To random play all tracks:
Press
RANDOM
repeatedly until “RDM ON” appears. Press
ENTER
.
To cancel random play:
Press
RANDOM
repeatedly until “RDM OFF” appears. Press
ENTER
.
Note
• If you press the
during random play, you can move
to the track selected next by the random operation. On
the other hand, the
does not allow you to move to
the previous track. The beginning of the track being
played will be located.
• In random play, the unit will select and play tracks
automatically. (You cannot select the order of the
tracks.)
• During random play, repeat play is not possible.
USB storage device
(commercially available)