USB playback
07
21
En
Chapter 7:
USB playback
Playing USB storage devices
It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be
supplied to a USB storage device. Also note that Pioneer
will accept no responsibility whatsoever for loss of files
on USB storage devices caused by connection to this
unit.
1
Press USB as the input source.
“
USB
/
IPOD
” is shown on the main display.
2
Connect the USB storage device.
The number of folders or files stored on the connected USB
storage device appear on the main display automatically.
• This receiver does not support a USB hub.
• If an iPod/iPhone/iPad is connected to the unit, the unit
will automatically begin charging it.
3
When the recognition is completed, press
to start playback.
• When changing to a different input source, stop the USB
memory playback first, before changing.
4
Disconnect USB storage device from the USB
terminal.
Turn the power off before removing the USB storage device.
Note
• USB flash drive that supports USB 2.0 can be used.
• This unit may not recognize a USB storage device, play
files or supply power to a USB storage device. For
details, see
When a USB storage device is connected
on
page 32.
• When a USB storage device is not playing and no
operations have been performed for more than 20
minutes, the unit will automatically power off.
• Auto power off can be switched to
ON
/
OFF
(page 35).
Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press
REPEAT
repeatedly until “RPT ONE” appears. Press
ENTER
.
To repeat all tracks:
Press
REPEAT
repeatedly until “RPT ALL” appears. Press
ENTER
.
To repeat desired tracks:
Perform steps 1 to 5 in “Programmed play (CD or MP3/WMA)”
section on next page and then press
REPEAT
repeatedly until
“RPT ALL” appears. Press
ENTER
.
To cancel repeat play:
Press
REPEAT
repeatedly until “RPT OFF” appears. Press
ENTER
.
Note
• After performing repeat play, be sure to press
.
Otherwise, the file of USB storage device will play
continuously.
• During repeat play, random play is not possible.
Random play
The file of USB storage device can be played in random order
automatically.
To random play all tracks:
Press
RANDOM
repeatedly until “RDM ON” appears. Press
ENTER
.
To cancel random play:
Press
RANDOM
repeatedly until “RDM OFF” appears. Press
ENTER
.
Note
• In random play, the unit will select and play tracks
automatically. (You cannot select the order of the
tracks.)
• During random play, repeat play is not possible.
USB storage device
(commercially available)
