En
3
English
1
POWER switch
Turns this speaker’s power on and off.
2
AC IN
Connect the power cord to AC IN and then to the power outlet.
3
Fuse holder
4
Power indicator
Lights in blue when the power is turned on.
5
MASTER LEVEL
Adjusts the output level.
6
EQ MODE SELECT
Switches to four EQ modes (FLAT, BASS+, SPEECH, and
WEDGE). For details, see “EQ MODE Settings” on page 6.
7
INPUT LEVEL knob
Adjusts the input signal level.
8
GAIN knob (for MIC/LINE1 only)
Select the gain according to the output signal level of the device
to be connected. The selected gain is added to the signal input to
this unit.
•
To input the signal of a line output device to this speaker,
select [0 dB] or [12 dB].
•
To input a low-level output signal such as that of a
microphone to this unit, select [24 dB] or [36 dB].
9
SIGNAL indicator
A green indicator lights when an input signal is detected.
a
MIC/LINE1 and LINE2 INPUT
Both the XLR connector (balanced) and 1/4” TRS (balanced
type PHONO) are supported. The XLR connector consists of 1
“ground,” 2 “hot,” and 3 “cold.”
b
LINK
This is the XLR output connector (balanced). A signal input to
XLR INPUT will be output directly. (A signal input to AUX IN of
LINE2 will not be output.)
c
LIMIT indicator
Lights in red when the built-in limiter is activated or when the
input level is too high and the sound is distorted. When that
happens, lower the output level of the connected device or lower
the input level or master level of this unit.
d
EXT SUB MODE
Select [
]for normal use.
Select [
] when using a subwoofer.
e
FRONT LED
Selects the display setting of the FRONT LED indicator (white).
[POWER] Lights when the power is turned on.
[LIMIT] Lights when the limiter is activated.
[OFF] The FRONT LED does not light.
f
AUX IN
These are the RCA input connectors (unbalanced).
A stereo signal input to AUX IN is mixed to a monaural signal (not
output from the LINK connector).
g
MIX OUT
This is the XLR output connector (balanced). Mixes the signal
input to MIC/LINE1 and Line2 and then outputs it.
A signal adjusted in MIC GAIN and INPUT LEVEL is output.
CAUTION
When the FRONT LED setting is set to [OFF] and [LIMIT],
the speaker may appear the same as when the power plug
is disconnected from the power outlet depending on the
specification of the product, but the power is not shut off. If you
wish to shut off the power to the woofer completely, you must
disconnect the power plug from the power outlet. Install the
speaker near a power outlet so the power plug can easily be
accessed. Leaving the power plug inserted in a power outlet for a
long period of time may cause fire.
Rear Panel Facilities (Full-Range Models)
1
2
3
5
4
6
b
8
a
9
b
a
9
7
c
e
d
g
f
7
