Pioneer XV-DV830 Service Manual Download

Page: 85 / 145

XV-DV830

7.1.7 ID NUMBER AND DATA SETTING

To enter ID Number Input Mode, with no ID number set, such as
in a case of immediately after upgrading the firmware, press the
ESC key then the STEREO key.

Note: If a previous ID number and ID data, such as a factory-

preset ID number and ID data, are maintained, the unit
enters ID Number Confirmation Mode when the above keys
are pressed. However, if only an ID number is maintained,
the unit enters ID Data Input Mode.

ID Number Input Mode

[Player's ID Number Setting]
ID Number ?
> - - - - - - - - -

<CLEAR> Exit

Input ID Number !

This display appears when the PLAY key is pressed in Step 4.
Enter a 9-digit number to compare. The number is also
displayed on the LCD display.

By pressing the CLEAR key without having input a number, the
unit returns to Step

without doing anything else. Each press

of this key after a number has been input deletes one digit.

After entering all 9 digits, if you press the PLAY key, the unit
compares the numbers input in Steps

and

, and only if the

numbers match, that number is set as the ID. Then the unit
automatically enters ID DATA Input Mode. If the numbers do not
match, the disc tray is opened, and the unit exits ID Number
Input Mode.

Enter a 9-digit ID number. The ID number is also displayed on
the LCD display.

By pressing the CLEAR key without having input a number, you
can exit this mode. Each press of this key after a number has
been input deletes one digit.

After entering all 9 digits, if you press the PLAY key, the unit
enters Compare mode. Enter the same ID number again. Only
if your two input numbers match, the ID number is set. Compare
mode helps eliminate mistyping of the ID number.

After entering all 9 digits, if you press the SEARCH key, the
unit unconditionally sets the input number as the ID number.
Then the unit automatically enters Player's Data Input Mode.
(The SEARCH key is not accepted after all 9 digits have been
entered.)

[Player's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?

<PLAY> Compare Mode
<SEARCH> Enter

Input ID Number !

[Player's ID Number Setting]
ID Number ?
0 0 0 0 0 0 0 0 1
Compare
>

∗

Input ID Number !

[Player's ID Number Setting]
ID Number ?
0 0 0 0 0 0 0 0 1
Compare
> 0 0 0 0 0 0 0 0 1 OK?

<PLAY> Enter

Input ID Number !

Note: Enter ID numbers while the unit is in Stop mode so that the values set will be immediately written to the flash ROM.

The following operations are all made with the TEST MODE remote control unit (GGF1381).

Caution:
For the DVD players compatible with DVD-RW, for playback of a DVD-RW disc (CPRM), it is necessary that an individual ID
number and ID data are set for each player. If the ID number and ID data be not properly set in the manner described below,
future operations cannot be guaranteed. The ID number is written on the yellow label at the rear panel of the player.
If there is no yellow label, before downloading FLASH ROM, take note of the ID number set following the procedures
outlined in "ID Number Confirmation Mode" on the next page.

Note: If you press the PLAY button before inputting a 9-digit ID

number, the unit returns to Step

without doing anything

else.

Note: If you press the PLAY button before inputting a 9-digit ID

number, the unit returns to Step

without doing anything

else.

www. xiaoyu163. com

QQ 376315150

TEL 13942296513