XV-HTD330
118
1
2
4
1
2
4
C
D
F
A
B
E
7.1.13 DISASSEMBLY
DIAGNOSIS OF PCBs
Note: For performing the diagnosis shown below, the following jig cables for service are required:
• GGD1160
• GGD1228
• GGD1315 (
×
2)
1
Remove the bonnet by removing the eleven screws.
2
Press the STANDBY/ON button to turn on the power.
3
Press the
0
OPEN/CLOSE button to open the tray.
4
Remove the tray cap.
5
Press the
0
OPEN/CLOSE button to close the tray.
6
Press the STANDBY/ON button to turn off the power.
1
Remove the two screws.
Rear Panel
Table Mechanism Section
2
Create a little gap between the main unit and the Table
Mechanism Section by holding and pulling up the rear side
of the Table Mechanism Section by hand.
3
Insert your hand through the gap below the Table
Mechanism Section.
4
Turn the gear pulley counterclockwise as viewed from the
top.
5
If the tray pops out a little, fully pull it out by a hand.
3
5
4
3
1
5
2 6
Tray Cap
2
3
4
Note when reattaching the bonnet
When reattaching the bonnet, to avoid damaging the unit, hook
the bonnet by supporting and lightly pushing it upward by hand
from the rear, as shown in the photo below.
How to open the Tray when the power cannot
be on
Hook
1
5
Gear Pulley
4
Gear Pulley
Bonnet and Tray Cap
1
Bottom View
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
