XV-HTD330
123
5
7
8
5
7
8
C
D
F
A
B
E
AF Assy
5
1
Remove the bonnet and tray cap. (See Step
¥
.)
9
Reattach the Table Mechanism Section.
(Be sure to secure it in place with screws.)
Turn the AF Assy with the Table Mechanism Section
attached to the upright position.
Arrange the cables as shown in the photo below.
12
11
10
Connect the AF Assy with the AMP Module Section using
a jig cable.
2
Remove the Front Panel Section. (See Step
ø
.)
3
Remove the Table Mechanism Section. (See Step
π
.)
4
Remove the AMP Module Section. (See Step
[
.)
6
Remove the four screws.
5
Remove the DVD Angle HTM by removing the two screws.
7
Remove the four screws.
8
Loosen the cord holder.
Rear Panel
AF Assy
DVDM Assy
AF Assy
Jig cable
(GGD1315)
Table Mechanism Section
AMP Module Section
PRIMARY Assy
6
A
A
A
7
7
12
10
11
6
6
6
5
Note on handling the rear panel
During diagnosis, be sure NOT to remove the four screws
marked
A
in the above photo. This unit will not operate if the
Audio Output connectors and the Speaker Output connectors of
the AF Assy are separated from the rear panel, because that
would break the circuit.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
