Additional Information
03
14
En
Troubleshooting
• Incorrect operations are often mistaken for trouble and malfunctions. If you think that there
is something wrong with this component, check the points below. If the trouble cannot be
rectified even after exercising the checks listed below, ask your nearest PIONEER autho-
rized service center or your dealer to carry out repair work.
• If you are experiencing problems with the wireless speaker system, make sure to bring both
the transmitter and the wireless speaker in for repair so that they can be tested properly.
Symptom
Cause & Remedy
The power does not turn on.
• Make sure the supplied power cord (or AC adapter) is fully
inserted into the AC IN inlet (or DC IN inlet).
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
Audio is interrupted.
• This system uses high frequency radio waves that have
properties similar to light, such as linearity, reflection, refraction,
diffraction, and interference. Therefore, placement of the system
can result in weak radio waves and/or interruption.
• The distance between the transmitter and
wireless speaker
may
be too large. Use the
wireless speaker
within the reach of radio
wave from the transmitter.
• The system may be close to a location generating electrical
noise. If this is the case, find a location that does not affect the
sound adversely.
Audio is suddenly interrupted. • There may be radio communication equipment using the same
frequency band (2.4 GHz) as this system, such as a Bluetooth
device, radio LAN device or microwave oven, operating nearby.
Audio cannot be received.
• The radio wave reception is variable depending on locations due
to the effects of obstacles and reflecting objects. Try changing
the location of the wireless speaker a little.
• The transmitter and wireless speaker are designed and sold as a
pair, and they identify each other in communication. This means
that communication is not available between separately
purchased transmitter and wireless speaker.
Horizontal stripe noise inter-
ference on a TV set near the
transmitter.
• Is there a piece of A/V equipment with an antenna near the
transmitter? If so, move the transmitter away from the antenna
input terminal of the AV equipment.
Caution
Static electricity or other external influence may cause malfunctioning of this unit. In this
case, unplugging the power cord and then re-plugging it in will usually reset the unit for
proper operation. If this does not correct the problem, please consult your nearest PIONEER
service center.
En_XW-HTP550.book 14 ページ ２００４年１１月１７日 水曜日 午前１０時２２分
