- 17 -
I
5. MANUTENZIONE ORDINARIA E
PROGRAMMATA
Le informazioni contenute in questo capitolo sono
destinate, per quanto riguarda la manutenzione ordinaria,
a personale non specializzato, ma addestrato e per quanto
riguarda la manutenzione straordinaria e/o programmata,
sono destinate a personale specializzato.
5.1 ELEMENTARI NORME DI SICUREZZA
Prima di eseguire qualsiasi intervento disinserire la presa
dell’apparecchiatura dalla rete di alimentazione elettrica.
5.1.1 PROIBIZIONE DELLA RIMOZIONE DEI RIPARI E
DEI DISPOSITIVI DI SICUREZZA
Per le operazioni di manutenzione ordinaria, è vietato
rimuovere i ripari/dispositivi di sicurezza (griglie, adesivi, ecc.).
5.1.2 INDICAZIONI SULLE OPERAZIONI DI
EMERGENZA IN CASO DI INCENDIO
ATTENZIONE:
In caso di incendio non usare acqua.
Premunirsi di estintore a CO
2
(anidride
carbonica) e raffreddare nel più breve
tempo possibile la zona del vano
motore.
5.2 PULIZIA DELL’ APPARECCHIATURA
Prima di qualsiasi operazione di pulizia, isolare
l’apparecchiatura dall’energia elettrica.
Pulizia e sistemazione accessori
Prima della messa in funzione:
Lavare l’interno cella e gli accessori con poca acqua e
sapone neutro per togliere il caratteristico odore di nuovo;
sistemare gli accessori interni della cella nelle posizioni
più consone all’uso.
Pulizia giornaliera
Pulire accuratamente le superfici esterne
dell’apparecchiatura usando un panno umido e seguendo
il senso della satinatura.
Usare detersivi neutri e non sostanze a base di cloro e/o
abrasive.
Non usare utensili che possono provocare incisioni con la
conseguente formazione di ruggine. Risciacquare con
acqua pura ed asciugare accuratamente.
Pulire l’interno cella per evitare che si formino residui di
sporco, con detersivi neutri non contenenti cloro e non
abrasivi. Nel caso di residui induriti usare acqua e sapone
o detergenti neutri, servendosi eventualmente di una
spatola in legno o plastica. Terminata la pulizia risciacquare
con poca acqua e asciugare accuratamente.
Non lavare l’apparecchiatura con getti d’acqua diretti,
poichè eventuali infiltrazioni nei componenti elettrici
potrebbero pregiudicarne il regolare funzionamento.
Anche le zone sottostanti e adiacenti l’apparecchiatura
devono essere giornalmente pulite, sempre con acqua e
sapone e non con detersivi tossici o a base di cloro.
Pulizia e manutenzione generale
Per un costante rendimento dell’apparecchiatura è bene
compiere le operazioni di pulizia e manutenzioni generali.
Per quanto riguarda la pulizia del gruppo frigorifero
(condensatore), deve essere fatta da personale
specializzato.
Pulire periodicamente la piletta di scarico per evitare che il
foro si ostruisca.
E’ ASSOLUTAMENTE IMPORTANTE RICHIUDERE IL
FORO CON L’APPOSITO TAPPO.
5.3 VERIFICHE PERIODICHE DA ESEGUIRE
- Controllare che la spina sia inserita correttamente nella
presa di corrente.
- Verificare che non ci sia influenza di una fonte di calore.
- Verificare che l’apparecchio sia perfettamente livellato.
- Verificare che la guarnizione della porta chiuda
perfettamente.
- Verificare che la piletta di scarico non sia ostruita.
- Verificare che la batteria condensante non sia intasata di
polvere e nel caso chiamare l’assistenza tecnica.
5.4 PRECAUZIONI IN CASO DI LUNGA INATTIVITA’
In caso di prolungata inattività dell’apparecchiatura:
- Spegnere l’apparecchiatura agendo sul pannello comandi
tasto off;
- Togliere la spina dalla presa di alimentazione;
- Vuotare il frigorifero e pulirlo accuratamente (vedi pulizia);
- Lasciare le porte del mobile socchiuse per favorire la
circolazione dell’aria ed evitare la formazione di muffe e/
o cattivi odori.
MANUTENZIONE STRAORDINARIA
Questo capitolo contiene informazioni destinate a
personale specializzato.
- Pulire periodicamente il condensatore.
- Controllare guarnizioni porte, verificare la perfetta tenuta.
- Controllare che l’impianto elettrico sia a norma.
- Controllare le resistenze cornici (mediante pinza
amperometrica).
IN CASO DI RIPARAZIONE O SOSTITUZIONE DI PARTI
RICORDARSI DI FORNIRE SEMPRE IL CODICE ED IL
NUMERO DI MATRICOLA DELL’APPARECCHIATURA,
CHE SI POSSONO RILEVARE DALLA TARGHETTA
CARATTERISTICHE.
6. SMALTIMENTO RIFIUTI E DEMOLIZIONE
6.1 STOCCAGGIO DEI RIFIUTI
E’ ammesso uno stoccaggio provvisorio di rifiuti speciali in
vista di uno smaltimento mediante trattamento e/o
stoccaggio definitivo. Vanno comunque osservate le leggi
vigenti nel paese dell’utilizzatore in materia di tutela
dell’ambiente.
Summary of Contents for RCM 121
