4-32. INSTALLATION OF WINDSHIELD. (Refer to Figure 4-5.)
a.
Be certain that the new windshield outside contours are the same as that of the old windshield. It may
be found that it is necessary to cut or grind the new windshield to acquire the proper dimensions.
b. Apply black vinyl plastic tape around the outer edges of the entire windshield.
c.
Apply Behr-Manning vinyl foam tape number 560 or equivalent over the plastic tape, completely
around the edges of the windshield.
d. Apply Behr-Manning sealant number PR 307 or equivalent under edge of the moldings and trim strips.
e.
Place the windshield in position for installation and slide the windshield aft and up into place, using
caution not to dislocate the tape around the edges. Allow clearance between the two windshields at the
divider post for expansion.
f.
Lay sealant at the bottom and center (inboard) of the windshield in the hollow between the outside
edge and channel.
g. Lay a small amount of sealant under the center trim strip, install and secure.
h. Lay black vinyl tape on the underside of the collar molding, install and secure.
i.
Seal with sealant any areas around windshield that may allow water to penetrate past the windshield.
j.
Remove excess exposed sealer to tape.
4-33. SIDE WINDOWS.
4-34. REMOVAL OF SIDE WINDOWS.
a.
Remove the retainer molding from around the window by removing the attachment screws.
b. Carefully remove the window from the frame.
NOTE
A damaged window should be saved to provide a pattern for shaping the
new window.
c.
Remove excess tape and sealer from the window frame and molding.
4-35. INSTALLATION OF SIDE WINDOWS. (Refer to Figure 4-6.)
a.
Cut or grind the new window to the same dimension as the window removed.
b. Apply Behr-Manning vinyl foam tape number 560 or equivalent, on both sides of the window around
the outer edges.
c.
Apply Behr-Manning sealant number PR 307 or equivalent, completely around the outer surface of the
windows at all attachment flanges.
d. Insert the window in the frame and install the retainer moldings.
e.
Secure the molding with attachment screws and tighten until the vinyl foam tape is 25% compressed
by the retainers.
f.
Remove the excess exposed sealer and tape.
Revised: 2/13/89
1E9
* CHEROKEE ARROW III SERVICE MANUAL
STRUCTURES
Summary of Contents for ARROW III
