1G21
TABLE V-III. TROUBLESHOOTING CHART (SURFACE CONTROLS) (cont.)
STABLIATOR CONTROL SYSTEM (cont.)
Resistance to stabilator
System not lubricated
Lubricate system.
control movement.
properly.
Cable tension too high.
Adjust cable tension
per Paragraph 5-16.
Binding control column.
Adjust and lubricate
per Paragraph 5-6.
Pulleys binding or
Replace binding pulleys
rubbing.
and/or provide clearance
between pulleys and
brackets.
Cables not in place on
Install cables cor-
pulleys.
rectly.
Cables crossed or
Check routing of control
routed incorrectly.
cables.
Bent stabilator hinge.
Repair or replace
stabilator hinge.
Incorrect stabilator
Stabilator stops
Adjust stop screws per
travel.
incorrectly adjusted.
Correct stabilator
Stabilator cables
Rig cables in accordance
travel cannot be
incorrectly rigged.
obtained by adjusting
stops.
Trouble
Cause
Remedy
Issued: 12/15/76
CHEROKEE ARROW III SERVICE MANUAL
SURFACE CONTROLS
Summary of Contents for ARROW III
