1G24
TABLE V-III. TROUBLESHOOTING CHART (SURFACE CONTROLS) (cont.)
STABILATOR TRIM CONTROL SYSTEM (cont.)
Trim tab fails to
System incorrectly
Check and/or adjust
reach full travel.
rigged.
Trim drum incor-
Check and/or adjust
rectly wrapped.
Trim indicator fails
Trim indicator unit
Adjust in accordance
to indicate correct
not adjusted properly.
trim position.
RUDDER CONTROL SYSTEM
Lost motion between
Cable tension too low.
Adjust cable tension
rudder pedals and
rudder.
Linkage loose or worn
Check linkage and
tighten or replace.
Broken pulley.
Replace pulley.
Bolts attaching rudder
Tighten bellcrank bolts.
to bellcrank are loose.
Excessive resistance
System not lubricated
Lubricate system.
to rudder pedal
properly.
movement.
Rudder pedal torque
Lubricate torque tube
tube bearing in need
bearings.
of lubrication.
Cable tension too high.
Adjust cable tension
Per Paragraph 5-29.
Trouble
Cause
Remedy
Issued: 12/15/76
CHEROKEE ARROW III SERVICE MANUAL
SURFACE CONTROLS
Summary of Contents for ARROW III
