CHECK OFF TOOLS AND SHOP MATERIALS NEEDED.
These tools and shop materials are not included and are required to complete and operate your model and most
other remote control aircraft.
CHECK OFF OTHER ITEMS NEEDED TO COMPLETE THIS SEMI SCALE SPORT MODEL
These items are not included and are required to complete and operate your VMAR MODEL and most other remote
control aircraft.
Medium fuel tubing appropriate for your choice of engine and fuel. 500 – 750 mm ( 24-36 in. )
Liquid thread locker
RC FM radio with at least four channels of control and on a frequency appropriate for your market area.
Five servos compatible with the RC FM Radio. Servos generally are provided with new radio systems
External Switch Actuator appropriate for your radio system ( optional )
Engine and muffler suitable for use in a remote control model aircraft. A two stroke glow fuel .40 -.53 cubic inch
engine is recommended.
Propeller suitable for the engine. See the engine instruction manual recommendation for diameter and pitch.
Engine glow plug
Engine glow plug igniter
Engine 4 way wrench
Fuel for the engine
“After run” oil for engine
RC Foam sheeting for wrapping the radio receiver and battery pack.
Two Servo extension long
CHECK OFF OPTIONAL EQUIPMENT AND ACCESSORIES.
These items are not included and are not required but make the operation of your model and most other remote
control aircraft easier & more enjoyable.
Power Tote Deluxe field box # VMA-PT109D
Fuel pump and connecting tubing
Fueling valve
Chicken stick or electric starter
Stick on weights
Battery to power electric starter
Battery charger
Power Panel to manage starter and pump if electric.
Extra propellers
Extra glow plugs
Misc tools
Engine test stand # VMA – ETS120
5
- Clean and flat table or work surface approximately
600 x 1800 mm ( 24 x 72 in. )
- 2.5 mm ball socket screw driver or Allen wrench
- 3.0 mm ball socket screw driver or Allen wrench
- 4.0 mm ball socket screw driver or Allen wrench
- Phillips ( cross head) screw driver small size
- Phillips ( cross head ) screw driver medium size
- Flat blade screw diver medium size
- Low tack masking Tape, Ruler or tape measure
- C/A glue
- Side ( “wire” ) cutters
- Pencil, pliers, hobby knife with #11 blade
- 30 minute Epoxy and 240 grit sandpaper
- Silicon Based Sealant (Dap – A – Goo )
- Epoxy mixing dishes, brushes and sticks
- Paper towels
- Rubbing alcohol
- Crescent wrench (optional )
- Heat gun and soft cloth for covering (optional for cov
ering touch up )
