ISSUED: JUNE 1, 1978
REPORT: VB-910
4-13
PIPER AIRCRAFT CORPORATION
SECTION 4
PA-28-236, DAKOTA
NORMAL PROCEDURES
LEFT WING
The wing surface should be clear of ice, frost, snow, or other extraneous
substances. Check that the fresh air inlet is clear of foreign matter and
remove the chock. Check the main gear strut for proper inflation, there
should be 4.5 inches of strut exposure under a normal static load. Check the
tire and the brake block and disc.
Open the fuel cap and visually check the fuel color and the quantity
should match the indication that was on the fuel quantity gauge, replace cap
securely. The fuel tank vent should be clear of obstructions. Drain enough
fuel to insure that all water and sediment has been removed.
Remove tie down and remove the cover from the pitot head on
the underside of the wing. Make sure the holes are open and clear of
obstructions. Check the wing tip and lights for damage. Check the aileron,
flap, and hinges for damage and operational interference and that the static
wicks are firmly attached and in good condition.
FUSELAGE
Check the condition and security on the antennas and that the holes
in the left static pad are clean and unobstructed. The empennage should
be clear of ice, frost, snow, or other extraneous substances and the fresh
air inlet at the top of the fin should be clear of foreign matter. Check the
stabilator and trim tab for damage and operational interference, the trim
tab should move in the same direction as stabilator. Remove the tie down.
Check that the holes in the right static pad are clean and unobstructed.
Upon returning to the cockpit, an operational check of the interior
lights, exterior lights, stall warning system, and pitot heat should now be
made. Turn the master switch and the appropriate switches ON. Check the
panel lighting and the overhead flood light. Visually confirm that exterior
lights are operational. Lift the stall detector on the leading edge of the left
wing and determine that the warning horn is activated. With the pitot heat
switch ON the pitot head will be hot to the touch. After these checks are
complete the master switch and all electrical switches should be turned
OFF.
Board the passengers and close and secure the cabin door. Fasten the
seat belts and shoulder harness and check the function of the inertia reel by
pulling sharply on the strap. Fasten seat belts on empty seats.
Summary of Contents for PA-28-236 DAKOTA
