A. Scheduled Maintenance (continued)
4.
Periodic Inspection (continued)
—
NOTE —
Refer to Notes 1, 2, 3, and 4 before performing inspections.
PIPER AIRCRAFT
PA-32R-301/301T
MAINTENANCE MANUAL
5-20-00
Page 5-15
Reissued: July 1, 1993
1C20
NATURE OF INSPECTION
F. WING GROUP (cont)
11. Inspect fuel tanks for capacity and minimum octane markings....................................
12.Inspect fuel cell vents (see note 15) ..............................................................................
13.Inspect all control cables, air ducts, electrical leads, lines, and attaching parts for
security, routing, chafing, deterioration, wear, and correct installation (see note 25) ..
14.Install inspection plates and fairings.............................................................................
G. LANDING GEAR GROUP
1. Check oleo struts for proper extension; check for proper fluid level as required. ........
2. Inspect nose gear steering control and level .................................................................
3. Inspect wheel alignment................................................................................................
4. Put airplane on jacks .....................................................................................................
5. Inspect tires for cuts, uneven or excessive wear, and slippage .....................................
6. Remove wheels, clean, inspect, and repack bearings....................................................
7. Inspect wheels for cracks, corrosion, and broken bolts ................................................
8. Check tire pressure........................................................................................................
9. Inspect brake lining and disc for wear ..........................................................................
10.Inspect brake backing plates for cracks ........................................................................
11. Inspect condition of brake and hydraulic lines .............................................................
12.Inspect shimmy dampener operation ............................................................................
13.Inspect gear forks for damage.......................................................................................
14.Inspect oleo struts for fluid leaks and scoring...............................................................
15.Inspect gear struts, attachments, torque links, retraction links, and bolts for condition
and security ...................................................................................................................
16.Inspect downlock for operation and adjustment ...........................................................
17.Inspect torque link bolts and bushings. Rebush as required. ........................................
18.Inspect drag and side brace link bolts. Replace as required..........................................
19.Inspect gear doors and attachments...............................................................................
20.Inspect warning horn and light for operation................................................................
21.Check normal-emergency gear retraction operation .....................................................
22.Retract gear-inspect doors for clearance and operation ................................................
23.Inspect anti-retraction system .......................................................................................
50 100 500 1000
O
O
O
O
O
O
O
O
O
O
O
O
O O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
Inspection time (hrs)
Summary of Contents for PA-32R-301T SARATOGA S
