Piper PA-34-200T Seneca II Service Manual Download

Page: 130 / 869

PIPER SENECA II SERVICE MANUAL

TABLE III-I. INSPECTION REPORT

(cont.)

Inspection

NATURE OF INSPECTION

Interval (Hrs)

100

30. Check throttle, alternate air, mixture and propeller

governor controls for security, travel and operating condition ............... O

31. Inspect exhaust stacks, connections and gaskets.

(Replace gaskets as required.)................................................................. O

32. Inspect breather tubes for obstructions and security ............................... O

33. Inspect crankcase for cracks, leaks and security of seam bolts .............. O

34. Inspect engine mounts for cracks and loose mountings.......................... O

35. Check rubber ending mount bushings for deterioration.

(Replace as required.) ............................................................................. O

36. Inspect all engine baffles for condition and security .............................. O

37. Inspect firewall seals ............................................................................... O

38. Inspect condition of alternator and starter............................................... O

39. Inspect all lines, air ducts, electrical leads and

engine attachments for security, proper routing,
chafing cracks, deterioration and correct installation ............................. O

40. Check air conditioning compressor oil level........................................... O

41. Check condition and tension of compressor drive belt.

(Refer to Service Manual, Section XIV.) ................................................ O

42. Check security of compressor mounting................................................. O

43. Inspect compressor clutch security and condition of wiring................... O

44. Lubricate all controls. (See Section II.) .................................................. O

45. Inspect and clean oil pressure relief valve .............................................. O

46. Inspect engine set-up per TCM SID97-3C or later.

See also paragraph 8-60 .......................................................................... O

C. TURBOCHARGER GROUP

Inspect all air inlet ducting and compressor discharge
ducting for worn spots, loose clamps or leaks. ....................................... O

Inspect engine air inlet assembly for cracks, loose
clamps and screws................................................................................... O

Inspect exhaust ducting and exhaust stacks for signs
of leaks or cracks. Check all clamps for tightness .................................. O

Carefully check all turbo support brackets, struts etc.,
for breakage, sagging or wear ................................................................. O

Perform V-Band Coupling 100-hour inspection,
per paragraph 8-27a. ............................................................................... O

Inspect all oil lines and fittings for wear, leakage,
heat damage or fatigue ............................................................................ O

Inspect bypass valve for security and safety ........................................... O

Run up engines, check all instruments for smooth,
steady response ....................................................................................... O

Piper PA-34-200T Seneca II, Service Manual

Search results

Summary of Contents for PA-34-200T Seneca II

Reviews:

Related manuals for PA-34-200T Seneca II

Brands by name

Popular brands