INSPECTION AND REPAIR OF PUMP.
1. Disassemble the pump.
2. The filter usually comes off with the cover; it may stick inside the fuel pump. Carefully remove the filter
and replace it, if distorted.
3. Check cover gasket and replace if deteriorated.
4. Check the O-ring seal and plunger spring and replace if worn.
ASSEMBLY OF PUMP. (Refer to Figure 21-15.)
1. Insert the plunger into the tube with the buffer spring end first. Check fit by slowly raising and lowering
the plunger in the tube. It should move fully without any tendency to stick. If a click cannot be heard, the
interrupter assembly is not functioning properly in which case the pump should be replaced.
2. Install the plunger spring, cup valve, O-ring seal and washer.
3. Compress spring and assembly retainer with ends of retainer in side holes of tube.
4. Place the cover gasket and magnet in the bottom cover and assemble the filter and cover assembly.
5. Twist the cover by hand to hold in position on pump housing. Using a 5/8 inch wrench, securely tighten
the bottom cover with the bayonet fittings on the pump body and install safety wire.
INSTALLATION OF HEATER FUEL PUMP.
1. Position the fuel pump on the forward bulkhead assembly and secure in place with bolts.
2. Connect the regulator to the pump outlet and the fuel line to the pump inlet.
3. Connect the electrical lead from the pump.
4. Operate the heater to make sure the unit is functioning properly.
5. Replace nose cone and secure.
DUCT SWITCH. (Refer to Figure 21-19.)
1. Removal:
A.
Disconnect the electrical leads from the terminals on the exposed face of the switch and mark to
facilitate installation.
B.
Remove the two attaching screws and washers from the duct switch bracket.
C.
Carefully lift out the switch and gasket (if gasket is used).
2. Cleaning and Inspection:
A.
Brush off any dust or lint from the switch operating mechanism (exposed inside the duct) and wipe
the external surfaces with a clean cloth.
3. Installation:
A.
Insert the switch carefully with gasket (if used) into the ventilating duct opening and secure with
the two attaching screws and washers.
B.
Connect the two electrical leads to their respective terminals on the face of the switch as marked
during removal.
C.
Operate the heater with the duct switch set above ambient temperature to check operation.
PA - 4 4 - 1 8 0 / 1 8 0 T
AIRPLANE MAINTENANCE MANUAL
2 1 - 4 3 - 3 3
Page 21-31
Revised: May 15, 1989
1F22
PIPER AIRCRAFT
Summary of Contents for SEMINOLE PA-44-180
