Piper SEMINOLE PA-44-180 Maintenance Manual Download

Page: 441 / 881

ASSEMBLY OF NOSE GEAR OLEO. (Refer to Figure 32-5.)

1. Ascertain that parts are cleaned and inspected.
2. To install the piston tube plug, first lubricate the tube plug and “O” ring with hydraulic fluid (MIL-H-5606)

and install the “0” ring on the plug. Lubricate the inside wall of the tube, insert the plug into the top of the
tube and push it to the fork end. Align the bolt holes of the fork, tube and plug, and install bolt assembly.

3. If desired, cement a cork in the hole in the bottom of the fork body to prevent dirt from entering between the

fork and tube.

4. To assemble the components of the orifice tube, insert the orifice plate into the bottom of the tube, with the

countersunk side of the orifice hole exposed. Secure the plate with the snap ring, lubricate and install the
“O” ring on the upper end of the tube.

5. Insert the orifice tube up through the bottom of the cylinder. With the tube exposed through the top of the

cylinder, install the lock washer and insert roll pin through the lock washer into the piston. Install the tube
lock nut finger tight at this time.

6. The fork and tube assembly may be assembled by installing the tube components on the tube. In order slide

onto the tube, the snap ring, washer, lower bearing with outer and inner “O” rings and upper bearing. Align
the lock pin holes in the upper bearing with the pin holes in the piston tube and install pins.

7. Lubricate the inner wall of the cylinder with hydraulic fluid. Carefully insert the piston tube assembly into

the bottom of the cylinder, allowing the orifice tube to guide itself into the fork tube, until the snap ring can
be installed in the annular slot at the bottom of the cylinder. Install wiper strip, slide washer into position
and secure assembly with snap ring.

8. At the top of the cylinder, tighten (torque) the orifice tube lock nut to 500 (min.) 600 (max.) inch pounds.
9. Ascertain that bushings are installed in the upper and lower torque links and then install both links. The

torque link bolt assemblies should be lubricated and installed with the flat of the bolt head hex adjacent to
the milled stop on the wide end of the link. Tighten the bolts only tight enough to allow no side play in the
link, yet be free enough to rotate.

10. Ascertain that the upper and lower oleo housing bushings are installed. Install the cylinder into the oleo

housing, position spacer washer(s) over the top of the cylinder and secure with snap ring. Install spacer
washers as required to obtain .0 to .015 of an inch thrust of the cylinder within the housing.

11. At the top of the oleo housing, install on the cylinder the aligner guide bracket and steering arm. Install cap

bolts, tighten 20 to 25 inch-pounds torque and safety with MS33540 wire.

12. Install the shimmy dampener and safety.
13. Lubricate the gear assembly. (Refer to Chapter 12.)
14. Compress and extend the strut several times to ascertain that the strut will operate freely. Weight of the gear

Piper SEMINOLE PA-44-180, Maintenance Manual

Search results

Summary of Contents for SEMINOLE PA-44-180

Reviews:

Related manuals for SEMINOLE PA-44-180

Brands by name

Popular brands