69
TAURUS ELECTRO
www.pipistrel.si
REV. 0
Aircraft and systems on board
Extending the propeller arm:
WARNING!
BEFORE EXTENDING THE PROPELLER ARM IN-FLIGHT, SET FLAPS TO T STAGE AND
REDUCE SPEED TO 80 KM/H (450KTS) OR BELOW.
1. Switch the System enable to ON (pull switch and move up).
This activates the system. Wait for System Status LED to turn GREEN (typically less than 5 sec).
2. Switch the Position selector switch to UP (pull switch and move up).
The electric brake will hold the propeller steady when it is moving towards the extended position.
Do not touch the unit until the LEFT status LED turns GREEN.
Running the motor (continued from Extending the propeller arm):
CAUTION!
BEFORE STARTING-UP THE ENGINE, VERIFY THE PROPELLER ARM IS EXTENDED AND
PROPELLER IN VERTICAL POSITION BY CHECKING THE COCKPIT MIRROR.
1. Confirm the “PROP CLEAR” message on the ESYS-MAN display
.
Confirm by clicking (pressing) the throttle knob. This is a safety precaution.
2. Rotate the throttle knob to select RPM (add power)
When the motor is running, the display will show motor RPM.
Also notice the throttle bar indicator.
Retracting the propeller arm:
WARNING!
BEFORE RETRACTING THE PROPELLER ARM IN-FLIGHT, SET FLAPS TO T STAGE
AND REDUCE SPEED TO 80 KM/H (45 KTS). A COOLING PERIOD IS NOT REQUIRED.
1. Reduce RPM to zero (rotate throttle knob left) and monitor the throttle bar.
Monitor the RPM dropping towards zero.
2. Switch the Position selector switch to DOWN (pull switch and move down).
The electric brake will initiate propeller positioning. Once propeller is positioned, the retrac-
tion will continue automatically. Do not touch the unit and wait until the RIGHT status LED turns
GREEN!
3. Switch the System enable switch to OFF (pull switch and move down).
This deactivates the system.
Shutting-down the motor IN FLIGHT:
WARNING!
WHEN IN FLIGHT, SHUTTING DOWN THE SYSTEM IS ONLY PREMITTED WHEN
THE PROPELLER IS IN THE RETRACTED POSITION. ON GROUND, THIS PRECAUTION IS NOT
VALID.
1. Retract the propeller arm
2. Switch the system enable switch to OFF (down)
WARNING!
ALWAYS WAIT BEFORE THE SYSTEM IS CONFIRMED IN FULL EXTENDED OR
FULL RETRACTED POSITION BEFORE OPERATING THE MASTER SWITCH OR THE SYSTEM
ENABLE SWITCH! THE PROPELLER BRAKE IS ELECTRIC AND DOES NOT WORK WITHOUT POW
ER. IN FLIGHT AND WITH THE SYSTEM IN THE MIDDLE OF RETRACTION, CUTTING THE POWER
WILL RESULT IN PROPELLER DAMAGE!
Summary of Contents for Taurus ELECTRO G2
